FARGO electronic DTC300M, DTC400 manual Safety Messages review carefully

RESTRICTED USE ONLYFargo Electronics, Inc.

Safety Messages (review carefully)

Symbol	Critical Procedures for Safety purposes
Danger:	Failure to follow these installation guidelines can result in death or
	serious injury.
	Information that raises potential safety issues is indicated by a warning
	symbol (as shown to the below).
	• To prevent personal injury, refer to the following safety messages
	before performing an operation preceded by this symbol.
	• To prevent personal injury, always remove the power cord prior to
	performing repair procedures, unless otherwise specified.
	• To prevent personal injury, make sure only qualified personnel
	perform these procedures.
Caution:	This device is electrostatically sensitive. It may be damaged if
	exposed to static electricity discharges.
	Information that raises potential electrostatic safety issues is indicated by
	a warning symbol (as shown to the below).
	• To prevent equipment or media damage, refer to the following
	safety messages before performing an operation preceded by this
	symbol.
	• To prevent equipment or media damage, observe all established
	Electrostatic Discharge (ESD) procedures while handling cables in or
	near the Circuit Board and Printhead Assemblies.
	• To prevent equipment or media damage, always wear an
	appropriate personal grounding device (e.g., a high quality wrist strap
	grounded to avoid potential damage).
	• To prevent equipment or media damage, always remove the
	Ribbon and Cards from the Printer before making any repairs, unless
	otherwise specified.
	• To prevent equipment or media damage, take jewelry off of fingers
	and hands, as well as thoroughly clean hands to remove oil and
	debris before working on the Printer.

DTC400/DTC300/DTC300M Firmware Upgrade Document (Rev. 1.3) 4