Kyocera 5035, 4035 If one of these indicators lights or flashes, Indication Procedure Reference

Section 9 TROUBLESHOOTING

Message	Procedure	Reference
		page
“Out of staples. Add staples.”	There are no staples in the optional Document Finisher. See the Document	——
[“Stapler empty. Add staples.”]	Finisher’s Operation Guide and replace the staple cartridge.
“Cannot staple this size.”	Stapling is not possible with small size paper. For details, see the optional Document	——
[“Cannot staple this paper size.”]	Finisher’s Operation Guide.
“Empty waste punch box.”	The hole punch chad container in the optional Document Finisher is full. Refer to the	——
	Operation Guide for your Document Finisher and dispose of the waste hole punch
	chads.
“Check the waste punch box.”	The hole punch chad container in the optional Document Finisher is not set properly.	——
[“Check Punch Hole box.”]	Refer to the Operation Guide for your Document Finisher and set the hole punch
	chad container properly.
“Replace the waste toner box.”	The waste toner box is filled with waste toner. Replace the waste toner box with a	10-3
	new one.

2. If one of these indicators lights or flashes

If one of the indicators to the left of the [Copier] key, the [Printer] key, or the [Scanner] key either lights orange or flashes orange, carry out the

appropriate procedure indicated below.

Indication	Procedure	Reference
		page
Lights orange or flashes	Check the appropriate response to the	–
orange	message, and perform the
	corresponding procedure.

9-3