Kyocera FS-1010 service manual Continue due to complex data

	Indicator	Remote Operation Panel display	Description
		Print overrun	Current print processing cannot
		Press GO	continue due to complex data.
			The data transferred to the printer was
			too complex to print on a page. Press
			the Go key to print data as far as it was
			stored. You can abandon printing by the
			Cancel key.
			Note: To release the page protect mode,
			send the following command to the
			printer from the Remote Operation
			Panel utility after this error occurs:
			!R! FRPO R5, 1; EXIT;
		MemoryCard err##	Check the error code displayed in ##
		Press GO	and refer to the appropriate description
			below.
			01: Abnormal format. Try turning the
			power off and on again.
			02: RAM disk mode is Off. Turn RAM
			disk mode On.
			04: No disk space. Clean up files.
			05: Specified file is not on disk.
			06: No memory for use by disk system.
			Expand printer memory.
			(Continued on next page)
		MemoryCard err20	The printer has halted because you
			attempted to insert/remove a memory
			card into/from the printer slot while the
			printer power is on.
			Turn the power switch off and then on
			to restart the printer.
			Note: Make sure to turn the printer
			power off before inserting/removing a
			memory card.
			(No indication patterns available)
(No		Format error	This message appears when the printer
indication		MemoryCard	is in the ready state and the memory
patterns			card is not formatted, and therefore
available)			cannot be read or written.
			Format the memory card.

FS-1010

6-9