Kyocera FS-1010 service manual Locking the toner container

7.Push the lock lever #1 1 to the lock position.

8.Close the top cover 4.

1

LOCK UNLOCK

4

K

C

O

L

K

C

O

L

N

U

	Figure- 2-2-5 Locking the toner container
NOTE	The printer is shipped from the factory with no toner supplied in its developer
	(Process unit). When the printer is first switched on after the toner container is
	installed in the manner above, there will be a delay of several minutes before
	the printer gets ready to print a job.
	This delay is necessary for the printer to fill the developer reservoir with a
	sufficient amount of toner to continuously support a print job. The period of
	time is approximately 15 minutes.
	If the toner low or replace toner indication does not go off after installing the
	new toner container, take the toner container out once, shake it well, then
	install again.

FS-1010

2-7