Connections
This section explains how to start up the printer.
Connecting the USB Cable
Follow the steps as below for connecting the USB cable.
1Connect the USB cable (not included) to the USB Interface Connector.
Note Use a USB cable with a rectangular Type A plug and a square Type B plug. The USB cable should be shielded and no longer than 5 meters (16 feet) long.
2Connect the other end of the USB cable to the computer's USB interface connector.
Connecting the Power Cord
Install the printer close to an AC wall outlet. If an extension cord is used, the total length of the power cord plus extension should be 5 meters (16 feet) or less.
Note Ensure the printer's power switch is off. Only use the power cord supplied with the printer.
1Connect the power cord to the Power Cord Connector at the rear of the printer.
2Connect the other end of the power cord to a power outlet.
3Press the Power Switch to On ( ). The printer begins to warm up.
IMPORTANT If you install the toner container and switch on the power, after a moment the indicators light in anticlockwise direction. When the printer is first switched on after toner installation, there will be a delay of approximately 15 minutes before the printer gets ready to print. Once the [Ready] indicator lights, printer installation is complete.
Connecting and Printing |