Enhancing photos automatically
1Load photo paper with the glossy or printable side facing you. (If you are not sure which side is the printable side, see the instructions that came with the paper.) For more information, see “Loading paper” on page 19.
2Insert a memory card or flash drive. For more information, see “Inserting a memory card” on page 20 or “Inserting a flash drive” on page 21.
3Press 
or 
repeatedly until View and Select appears on the display.
4Press 
.
5Press 
to continue.
6Press 
or 
to navigate through the photos.
7Press 
to select a photo for printing.
8Press 
.
The Photo Edit Mode menu appears.
9Press 
or 
repeatedly until Auto Enhance appears on the display.
10Press 
or 
to select On.
Note: The image on the display does not accurately reflect the image when printed.
11Press 
to save your selection and go back to the photo selection screen.
An icon appears on the bottom of the display to indicate that the photo will be auto enhanced when printed.
12Press 
or 
to select the number of copies to print.
Note: Pressing 
when the number of copies is set to 1 will deselect the image. Pressing 
when the image is not selected will select the image.
13You can select more photos for printing and editing by repeating step 6 through step 12.
14Press 
to go to the Print Preview screen.
15If you want to adjust the print settings:
aPress 
.
bMake your selections.
cPress 
to save your selections, and then go back to the Print Preview screen.
16Press 
to print.
Note: To prevent smudging or scratching, avoid touching the printed surface with your fingers or sharp objects. For best results, remove each printed sheet individually from the paper exit tray, and allow the prints to dry at least 24 hours before stacking, displaying, or storing.
Editing photos
32