Lexmark N8050 manual Configuring the authentication mechanism

Page 13

5Select the appropriate encryption for the network. The type of encryption that can be used is dependent on the authentication type that was selected in step 4.

For Open:

No Encryption

WEP

For Shared:

WEP

For WPA Personal:

TKIP

For 802.1x–RADIUS:

No Encryption

WEP (dynamic keys)

WEP (static keys)

WPA-TKIP

6If 802.1x–RADIUS using EAP-TLS is the intended authentication type, a certificate request is needed to obtain a signed certificate for the device. For instructions on requesting a new signed certificate, see Creating a certificate request. If a different 802.1x–RADIUS authentication mechanism is used, skip to step 7.

7Configure authentication and encryption. If none of the following options are selected, continue to step 8.

If 802.1x–RADIUS was selected as the authentication type, click Configure Authentication, and follow the Configuring the authentication mechanism instructions.

If WPA Personal was selected as the encryption type, click Configure Encryption, and follow the Configuring WPA Personal encryption instructions.

If WEP or WEP (static keys) was selected as the encryption type, click Configure Encryption, and follow the Configuring WEP encryption instructions.

8Click Apply.

9Click OK.

10Click OK to close the utility.

Configuring the authentication mechanism

If EAP-MD5, MSCHAPv2, or LEAP is selected as the authentication mechanism:

1Enter an appropriate username and password for the 802.1x–RADIUS authentication server.

2Confirm the password.

Using the Wireless Setup Utility

9

Image 13
Contents MarkNet N8050 Internal Wireless Print Server Edition May Contents Glossary Unpacking your print server Getting startedAttaching the wireless print server antenna Safety informationWireless network settings Minimum requirements for setupConfiguration overview Configuringserver the internal wireless printClick Install MarkNet N8050 Utilities Using the Wireless Setup UtilitySelect either Wizard Mode or Advanced Mode Wireless Configurations Found on Your Computer For Wizard ModeWireless Networks Available in Your Area Entering alternate network settings For Advanced Mode Configuring the authentication mechanism Click Install Signed Certificate Click Install CA CertificateConfiguring WEP encryption Installing the printer on the networkInstalling a network printer on additional network computers Finding the network printer IP address Changingsettings the wireless print serverClick Launch Web MarkNet N8050 Utilities CD does not launch automatically TroubleshootingNetwork key was invalid Printer was unable to join the network My network printer does not print Configuring the print server in Ad-Hoc mode Manual configurationConfiguring the print server in Ad-Hoc mode Click Certificate Management Certificate managementClick Update Certificate Signing Request To request and install a new Signed CertificatePeap GlossaryGlossary Glossary Statement of Limited Warranty for MarkNet N8050 Certification ID W003404