Lexmark N8050 manual My network printer does not print

Page 20

My network printer does not print

Make sure the printer power is on.

Check the printer status.

Make sure the network is operating properly.

See the network documentation, or contact your network support person if you are not sure that your network is operating correctly.

Make sure the printer driver is installed on the computer from which you are sending the print job.

Note: The printer driver must be installed on each computer that uses the network printer.

Make sure the correct printer port is selected.

Restart the computer.

Uninstall and then reinstall the printer software.

If the printer still does not print, see the printer documentation for help.

Make sure there is not a problem with the printer itself.

Attach the printer directly to the computer with a USB cable, and perform a local printer installation. If you are able to print when the printer is directly attached, there may be a problem with the network. See the network documentation, or contact your network support person.

My network printer does not print

16

Image 20
Contents MarkNet N8050 Internal Wireless Print Server Edition May Contents Glossary Getting started Unpacking your print serverSafety information Attaching the wireless print server antennaMinimum requirements for setup Wireless network settingsConfiguringserver the internal wireless print Configuration overviewSelect either Wizard Mode or Advanced Mode Using the Wireless Setup UtilityClick Install MarkNet N8050 Utilities Wireless Networks Available in Your Area For Wizard ModeWireless Configurations Found on Your Computer Entering alternate network settings For Advanced Mode Configuring the authentication mechanism Click Install CA Certificate Click Install Signed CertificateInstalling the printer on the network Configuring WEP encryptionInstalling a network printer on additional network computers Click Launch Web Changingsettings the wireless print serverFinding the network printer IP address Network key was invalid TroubleshootingMarkNet N8050 Utilities CD does not launch automatically Printer was unable to join the network My network printer does not print Manual configuration Configuring the print server in Ad-Hoc modeConfiguring the print server in Ad-Hoc mode Certificate management Click Certificate ManagementTo request and install a new Signed Certificate Click Update Certificate Signing RequestGlossary PeapGlossary Glossary Statement of Limited Warranty for MarkNet N8050 Certification ID W003404