Lexmark N8050 manual Entering alternate network settings

Page 11
Note:

Entering alternate network settings

Once the Wireless Setup Utility has collected and displayed the existing wireless settings, if the network configuration you want to use is not available, you have the option to enter a different network configuration.

1After the Setup Wizard performs the site survey, select the option to enter a different configuration.

If wireless network configurations were found on your computer:

From the Wireless Configurations Found on your Computer screen, select the I want to enter a different configuration radio button, click Next, and then go to step 2.

If no wireless network configurations were found on your computer:

From the Wireless Networks Available in Your Area screen, select the I want to enter a different network name radio button, click Next, and then skip to step 3.

2From the Wireless Networks Available in Your Area screen, select the I want to enter a different network name radio button, and then click Next.

3Select the wireless mode for your network (Infrastructure or Ad-Hoc mode).

4Enter the Network Name (SSID) of the network that you want to use.

The SSID must be entered exactly as it is used on the network. SSID’s are case-sensitive, so if the SSID is entered incorrectly, the print server will not be able to communicate on the network, and the configuration process must be repeated.

5Select the appropriate channel for the network (if applicable).

6Click Next.

7Select the type of security that your network uses, and then click Next.

8If security was selected, enter the appropriate security key(s), and then click Next. If no security was selected, proceed to step 9.

9Check each network attribute on the summary screen to make sure that the settings are correct. If the settings are correct, click Next to apply these settings to your print server.

Note: Clicking Next will prompt the setup utility to verify wireless communication with the printer. This verification process can take up to 120 seconds. If you are sure that the wireless settings displayed on the screen are correct, and you do not want to initiate the wireless verification process, or if the print server is being configured for use on a network that is not immediately available to either the printer or the configuring computer, click the Do not verify the print server can join the network check box to skip the wireless verification test, and go to step 11.

Using the Wireless Setup Utility

7

Image 11
Contents MarkNet N8050 Internal Wireless Print Server Edition May Contents Glossary Unpacking your print server Getting startedAttaching the wireless print server antenna Safety informationWireless network settings Minimum requirements for setupConfiguration overview Configuringserver the internal wireless printSelect either Wizard Mode or Advanced Mode Using the Wireless Setup UtilityClick Install MarkNet N8050 Utilities Wireless Networks Available in Your Area For Wizard ModeWireless Configurations Found on Your Computer Entering alternate network settings For Advanced Mode Configuring the authentication mechanism Click Install Signed Certificate Click Install CA CertificateConfiguring WEP encryption Installing the printer on the networkInstalling a network printer on additional network computers Click Launch Web Changingsettings the wireless print serverFinding the network printer IP address Network key was invalid TroubleshootingMarkNet N8050 Utilities CD does not launch automatically Printer was unable to join the network My network printer does not print Configuring the print server in Ad-Hoc mode Manual configurationConfiguring the print server in Ad-Hoc mode Click Certificate Management Certificate managementClick Update Certificate Signing Request To request and install a new Signed CertificatePeap GlossaryGlossary Glossary Statement of Limited Warranty for MarkNet N8050 Certification ID W003404