Philips PCA82CR, PCA102CD user manual Installing Your Drive, Installing the CD-ROM Drive

Page 20

INSTALLING YOUR	3
DRIVE

This chapter contains detailed instructions to guide you through the installation of your new CD-ROM drive.

To install the drive, your PC must have at least one free IDE interface connector. If not, you need to go to a computer retailer and buy an IDE controller card (an Enhanced IDE controller card is needed if your PC already has a one-port IDE controller). See Appendix A for a brief introduction to IDE connections.

3.1 Installing the CD-ROM Drive

Here’s how to install your CD-ROM drive:

1.Adjust the Master/Slave jumpers on the back of the CD-ROM drive as necessary. (The factory setting of the slave mode meets most people’s needs and normally does not need to be changed. See Appendix A.)

2.Disconnect the power to your PC and remove your PC's casing.

3.Slide the CD-ROM drive into the mounting rails of a 5.25” drive bay.

3

5

Image 20

Contents Philips CD-ROM Drive Table of Contents Copyrights And Liabilities Printed Taiwan FCC Notice USA IiiCDC Regulatory Statement Canada S.F1. Regulatory StatementPage Important Safety Notice Belangrijke veiligheidsvoorschriftenAvis important en matière de sécurité ViiWichtiger Sicherheitshinweis Page Precauzioni Importanti Importante Advertencia de Seguridad Features INTRODUCTION1Package Contents System RequirementsPage During Operation PRECAUTIONS2During Installation When Handling a Disc During TransportServicing the Drive Installing Your Drive Installing the CD-ROM DriveConnector on the back of your CD-ROM drive Back of the drive to Sound Card That has two 2-pin Molex or equivalent connectors Installing Your Drive Letting Your System Recognize Drive If You Are a DOS or Windows UserCD-ROM Device Driver Setup Menu Philips CD-ROM Drive USER’S Manual If You Are a Windows 95 User My Computer PeripheralsFolder appears 315 System Properties FolderPhilips CD-ROM Drive USER’S Manual System Configuration Dialog Box If You Are an OS/2 Warp UserFollowing window appears 10 The Command Prompts Icon View Window 319This page is intentionally left blank Front Panel Controls Using Your CD-ROM DriveDrive Applications Headphone Master or a Slave DEVICE? IDE ConnectionsPhilips CD-ROM Drive USER’S Manual Figure A-2 Enhanced IDE Controller Card Device, their assignments may look similar to the following 231 Setting Master and Slave Jumpers Slave Mode Master Mode251 Specifications B Audio FeaturesPower Requirements InterfaceDC 5V +/- 5% MA typical Environmental Tolerance Physical CharacteristicsReliability