Philips PCA82CR, PCA102CD user manual 231

Page 42

	A MASTER OR A SLAVE DEVICE
Device 1	Primary master (boot
	drive)
Device 2	Primary slave
Device 3	Secondary master
Device 4	Secondary slave
Device 5	Tertiary master
Device 6	Tertiary slave
.	.
.	.
.	.

Note that the primary master, if configured, must be a boot drive (normally a hard disk). Other than this, an IDE device can be configured to any IDE interface port and either as a master or a slave at your own choice. Here master and slave do not imply any operating precedence; they are just the “sub-IDs” of the devices that your computer needs to know about.

Note: 1. Currently, a CD-ROM drive cannot be used as a boot drive. Therefore, you cannot configure the CD-ROM drive as the primary master.

2.Your CD-ROM can be attached to any IDE controller that supports up to eight IDE devices.

3.If you are using OS/2 Warp and another device has already been configured as the primary slave, we highly recommend that you configure the CD-ROM drive as the master device of one of the rest available IDE ports.

A

231

Image 42

Contents Philips CD-ROM Drive Table of Contents Copyrights And Liabilities Printed Taiwan FCC Notice USA IiiCDC Regulatory Statement Canada S.F1. Regulatory StatementPage Important Safety Notice Belangrijke veiligheidsvoorschriftenAvis important en matière de sécurité ViiWichtiger Sicherheitshinweis Page Precauzioni Importanti Importante Advertencia de Seguridad Features INTRODUCTION1Package Contents System RequirementsPage PRECAUTIONS2 During InstallationDuring Operation When Handling a Disc During TransportServicing the Drive Installing Your Drive Installing the CD-ROM DriveConnector on the back of your CD-ROM drive Back of the drive to Sound Card That has two 2-pin Molex or equivalent connectors Installing Your Drive Letting Your System Recognize Drive If You Are a DOS or Windows UserCD-ROM Device Driver Setup Menu Philips CD-ROM Drive USER’S Manual If You Are a Windows 95 User My Computer PeripheralsFolder appears 315 System Properties FolderPhilips CD-ROM Drive USER’S Manual System Configuration Dialog Box If You Are an OS/2 Warp UserFollowing window appears 10 The Command Prompts Icon View Window 319This page is intentionally left blank Using Your CD-ROM Drive Drive ApplicationsFront Panel Controls Headphone Master or a Slave DEVICE? IDE ConnectionsPhilips CD-ROM Drive USER’S Manual Figure A-2 Enhanced IDE Controller Card Device, their assignments may look similar to the following 231 Setting Master and Slave Jumpers Slave Mode Master Mode251 Power Requirements Specifications BAudio Features InterfaceDC 5V +/- 5% MA typical Physical Characteristics ReliabilityEnvironmental Tolerance