LFF6020
Starting your device | 1 Select the desired language using the or |
| buttons and confirm with OK. |
|
Device connection
Before plugging the power cord, it WARNING is imperative to refer to the
Security directives, page 1.
1Make sure that the On/Off switch is on Off (O position).
2Connect the power cord to the device. Plug the power cord to outlet on the wall.
The setup is now complete and the functions list is automatically printed out.
The LCD screen displays the message PAPER EMPTY if no paper has been loaded in the paper tray (see Loading paper in the main unit tray, page 10). Once paper has been loaded, printing will resume.
Paper insertion in the manual input tray
Before inserting paper, refer to the Important paragraph Paper
recommendations, page 10.
The manual input tray allows you to use various paper formats with greater grammage than the one used in the paper feed cassette (refer to the paragraph Specifications, page 49).
Only one sheet or envelope can be fed at a time.
Important | You can use paper weighing | |
between 52 and 160 g/m². | ||
|
The power cord is used as a power unit cut off. As a precaution, the
WARNING outlet shall be located close to the device and be of easy access in case of danger.
3Press the On/Off button to turn on the device (I position).
Device initial setup
After a few seconds, when the machine has warmed up, the Easy Install function is launched and the LCD screen displays the following message:
1 - FRANCAIS
2 - ENGLISH
The Easy Install function will help you configure your machine by guiding you through the basic settings.
If you wish to modify the setting displayed, press the OK button. If you do not want to modify the displayed setting, press the C button: the Easy Install function then displays the next basic setting.
| If you do not want to carry out the | |||
| initial setup, press the | button. A | ||
Note | confirmation message appears. Press | |||
the | button again to confirm. | |||
| ||||
To manually modify and customise the machine settings, refer to Parameters/Setup, page 22.
1Spread the manual feed guides to the maximum.
2Insert a sheet or an envelope in the manual input tray.
3Adjust the paper guides against the right and left edges of the sheet or the envelope.
4Print making sure that the chosen paper format corresponds to the selected format on the printer (refer to Copy, page 18).
Use of envelopes
•Feeding can be done only through the manual feed.
•Recommended area should be the area which excludes 15 mm from the leading edge, 10 mm from both the left and right edges, and the rear edge.
•A few lines may be given in solid print at the part of being overlapped.
•Envelopes which are not recommended may lead to improper printing (refer to the paragraph Specifications, page 49).
•Curled envelope after printing should be fixed manually.
•Small crumples on the edge of the wide side of envelopes, smearing, or less clear printing may
- 16 -