Xerox SquareFold Trimmer manual Problem solving, Jam clearance

Page 19

Problem solving

Jam clearance

Tip

The top covers cannot be opened during normal operation or when the machine is idle. The covers can be opened only when an indicator is lit (refer to page 4) and a jam/fault occurs within the SquareFold Trimmer Module.

If a jam occurs, the machine stops printing, and a message may be displayed on the User Interface (UI).

Clear any paper jams that may occur along the paper path

Tip

To determine if the jam/fault is within the finisher or with the SquareFold Trimmer Module, always begin your troubleshooting with the SquareFold Trimmer Module.

Use the following procedure to clear the jam or fault and resume printing:

1.Follow the instructions displayed on the machine's UI.

2.If instructed by the machine's UI, open the Top Left Cover and the Top Right Cover of the SquareFold Trimmer Module.

3.Look for any jammed booklets within the SquareFold Trimmer Module paper path and remove them.

4.Check for loose trim scraps along the paper path and remove them.

5.Close the Top Left and Right Covers.

6.Empty the Trimmer Waste Container.

User Guide

15

Image 19
Contents User Guide Page Table of contents Table of contents Introduction OverviewMain components Identifying the componentsPaper path Control panel Accessing the Square Fold options Square Fold featureNetwork print jobs Booklet Trimming / Pressing Square Fold optionsOverview Accessing the Trimmer options Trimmer featureNetwork print jobs Trimmer options Lbs./g/m² Setting mm Printing full-page images on booklets Hints and tipsFollow these tips Jam clearance Problem solvingProblem solving Fault Codes Check the Trimmer Waste Container If fault persists, power off/on the copier/printer Problem solvingSquareFold Trimmer Module Physical characteristics SpecificationsTechnical data