SERVSWITCH™ BRAND FIBER KVM EXTENDERS
3.3.1THE
The Local Module of the ServSwitch Brand Fiber KVM Extender adds synchronization signals to the color signals for transmission across the fiber link. If you are using a VGA monitor (which is probably not equipped to handle sync on color), you will want the Remote Module to use its decoupling diodes to strip this sync information from the color signals, so you will leave the jumper posts at locations JP1, JP2, and JP3 empty (the default setting) so that these diodes will be active. But if you are using an RGB monitor (which is probably designed to receive sync on color), you will want the Remote Module to leave the sync signals combined with the color signals, so you should install jumpers at JP1, JP2, and JP3 to deactivate the decoupling diodes, as shown in Figure
CAUTION!
The
Diode active, sync stripped | Diode inactive, sync on color |
(factory default) |
|
JP1
JP2
JP3
Removed | Installed |
Figure 3-7. The sync-on-color jumpers and diodes.
20