Fujitsu manual 2XG2000 Components, XG2000 front

1-2XG2000 Components

This section explains the names and functions of the various XG2000 components, including the various indicator LEDs.

XG2000 front

The following explains the names and functions of the components at the front of the XG2000.

Port 1 - 20		Mng-LAN Speed LED
		Mng-LAN Link LED
upper stand : odd number
	Link/Act LED
lower stand : even number		Serial Port
	Link/Act LED	Dump Switch
		Mng-LAN
		Status LED (Status)
		Alarm LED (Alarm)
		Power LED (Power)

•	Ports 1-20		XFP modules which connect to the IEEE802.3 ae/ak compliant
			10 Gigabit network served by the XG2000. Connection method
			varies depending on which XFP modules are installed.
•	Link/Act LEDs (Green)		Displays the condition of respective port.
			Each LED lights when a link is established on its port.
			The link is established about few seconds after the received
			signal is detected.
•	Dump Switch		Used to collect maintenance information.
•	Mng-LAN		Used when performing maintenance or adjusting the settings
			(LAN connection).
	-	Mng - LAN Speed LED (Orange) Lights if the link is 100BASE-TX.
	-	Mng - LAN Link LED (Green)		Lights when the link is established.
•	Serial Port		Used when performing maintenance or adjusting the settings
			(Console connection).
•	Status LED (Green)		Lights when the XG2000 is in an operable state.
•	Alarm LED (Orange)		Lights when there is a problem with the XG2000.
•	Power LED (Green)		Lights when the XG2000 is receiving power.

16

Installation