Fujitsu XG2000 manual 3Installation of XFP modules, Installing the XFP modules

Page 33

2-3Installation of XFP modules

This section describes the installation of the XFP modules.

2-3-1 Installing the XFP modules

The following explains how to install the XFP modules in the XG2000.

1. Install the XPF module in the XG2000.

How to install the XFP module is the following,		2
(1)	Insert the XFP module with the cable connector facings outward. In cases installing the
	XFP module in an odd port number, the slot connector facings down. Otherwise, in cases
	installing the XFP module in an even port number, the slot connector facings up.
(2)	Slide the XFP module into the slot until it snaps into place without the lever lifting.

Label

Installation of XFP modules

31

Image 33

Contents XG2000 Hardware Guide Page Preface For Safe Use of the XG2000 For Safe Use of the XG2000Not used properly XG2000 is not used properly No self maintenance Safety precautionsFor security Electromagnetic compatibility USA SafetyElectromagnetic compatibility Canada Electromagnetic compatibility EULaser safety High safetyTargeted reader and expected knowledge About This ManualOrganization Related manualsSymbols used in this manual Trademarks and abbreviations used in this manualProduct Information About This Manual Contents Chapter Troubleshooting Installation CD-ROM 1Parts ListParts List XG2000 front 2XG2000 ComponentsXG2000 rear LED Display LEDs3Labels FCC Label FCC Canada LabelCSA/CE Label Product nameplate Product ID LabelMAC Label Xxxxxxxxxxxx+14 Installation and Operation 1Installation Overview 2Installation Procedure Installation requirementsSpace requirements Installing the XG2000 in a rack Set up requirementsTake the XG2000 out of its box Fix the nuts and rails to the rack posts When the rack has round post holes top of viewWhen the rack has round post holes Slide the XG2000 into the rack and fasten it in place Fix the four rack mounting brackets to the XG2000Uninstalling the XG2000 from a rack This completes the rack installation procedureSlide the XG2000 forward, and remove it from the rack 3Installation of XFP modules Installing the XFP modulesInstall the XPF module in the XG2000 Uninstall the XPF module from the XG2000 Uninstalling the XFP modulesConnecting the fiber optic cables 4Cable ConnectionConnect the fiber optic cables to the XG2000 Connect the power cords to the XG2000 Connecting the power cords5Basic Operation Turning the XG2000 onTurning the XG2000 off Installation and Operation Troubleshooting Alarm LED lights, but the XG2000 does not start up 1Start-up ProblemsXG2000 does not turn on Status LED blinks, but the XG2000 does not start up2Hardware Problems Troubleshooting Appendix Appendix-ASpecifications Product SpecificationsInstallation Specifications XG2000 Hardware Guide