Black Box ACU5501A-R4, ServSwitch Wizard DVI/USB SRX manual Power connections optional

ServSwitch Wizard DVI/USB SRX

3.2.1.6 Power connections (optional)

The local module is designed to derive its power from the host computer via the USB connection (two connections for the dual variant). If this is not possible, then you will need to use one or two optional Black Box power adapters.

1Connect the output lead of the optional power adapter(s) to the socket(s) labeled ‘POWER‘ on the local module as shown in Figures 3-11 and 3-12:

WER PO

	w
S
v	B
r
e
S

Single-variant local module: Use an optional power adapter only if powering from the host (via USB) is not possible.

Figure 3-11. Attaching the power adapter connection to the single variant local module

LOCA

IN

WER

PO

Do not use squid cables or

power splitters. Two separate power adapters must be used.

r e S

Dual-variant local module: Use two optional power adapters only if powering from the host (via dual USB connections ) is not possible.

Figure 3-12. Attaching the power adapter connections to the dual variant local module

2Insert the IEC connector of the separate power cord(s) into the corresponding socket(s) of the power adapter(s). Connect the other end of the power cord to one/two nearby mains socket(s).

Note: After all connections are made, power up the monitor and the REMOTE module first (followed by the LOCAL module, if using the dual-variant with power adapters) and then switch on the computer.

Page 14 724-746-5500 blackbox.com