Black Box ServSwitch Wizard DVI/USB SRX, ACU5501A-R4 manual Installation, Rack mount

Chapter 3: Installation

3.1.2 Rack mount

Note: The module switches are not accessible once it is inserted into the rack, therefore, check all settings before insertion.

1Place the rack securing plate (available as a separate kit) onto the front of the module and secure it with the two countersunk screws.

2Orient the ServSwitch Wizard DVI/USB SRX module on its side so that its labeled face is the correct way up.

3Slide the module into the required rack position. The rectangular cut-out in the front upper lip of the rack allows the two screws on the module’s upper edge to slide through.

4The rack mount chassis has a series of holes in its floor that are spaced to accommodate the two screws on the module’s lower edge. Ensure that the screws correctly locate into the two holes of the chosen slot. The rack securing plate on the module should now be flush with the front of the rack mount chassis.

5Use the third (pan-head) screw, in the top hole of the rack securing plate to fasten the module to the rack as shown in Figure

3-2:

TE

S
e
r
v
S
B	L

i
	t
A	c
	C	K

™

B

i
O	z	a
	X

K	V
		M

I
E	/
	X
		T
			E
				N
					D
						E

TO

R

LINK LOCAL

ON

Figure 3-2. Fixing the module into the rack

724-746-5500 blackbox.com Page 9