GarrettCom Magnum 700X manual Installing PM Cards, Installing the PM Card, Each PM card fits

Magnum 700X Mini-Concentrators Installation and User Guide (05/98)

2.Remove PM Retaining Screws

On the front of the unit there are two retaining screws for each PM card slot. These screws are used to secure the face plate in position. These screws are also used to secure individual PM modules. (See Figure 3.3c).

Magnum 700X

Magnum 700X Chassis

PM

Retaining

Screws

Chassis

Base

Figure 3.3c: Front Panel View - PM Retaining Screws

Once the face plate or PM has been removed, proceed to Section 3.4 and install the PM

card.

3.4Installing PM Cards

Up to seven assorted PM (Port Module) cards are easily installed in the Magnum 700X Mini-Concentrator chassis. The installation procedure for PMs is described below.

1.Removing 700X Chassis Cover and PM Retaining Screws

Follow the procedure described for Face Plates in Section 3.3, Steps 1 and 2, above.

		RPM Retaining
		Screw Hole
2.	Installing the PM Card	- PM Media Interface	PM Mounting
			Plate
	Each PM card fits	- ST (Fiber)
		- SMA (Fiber)
		- BNC (ThinNet)
	easily into any available	- AUI (ThickNet)
		- RJ-45 (Twisted Pair)	Magnum
		- DTE (RS-232)	PM Card
	connector socket slot.	- SMF (Fiber)
	Align the connector
	pins on the PM card	PM	Eight (8) Pin
			PM Conector
		Retaining
	with the connector	Screw Hole
	socket inside the unit.	Side View of PM Card

GARRETT

24