Magnum 700X Mini-Concentrators

Installation and User Guide (05/98)

 

 

The internal power supply is auto-ranging to handle any AC power type worldwide. Power input may range from 90 to 260 vac, with a frequency rating of 47 to 63 Hz. The unit is equipped with a rear mounted IEC-type recessed male AC power connector. (When shipped for use in areas other than 115 vac, a power cord will not be included). The 700X unit is convection cooled for silent operation.

2.3Magnum 700X - Repeater Port Modules (RPMs)

There are a total of six different RPM cards and each is designed with its own media cable connector type. A seventh module is used as a face plate when any front slot is not used.

The assortment of standard network connector types for RPMs includes BNC (ThinNet or 10BASE2), AUI (10BASE5 or ThickNet, DB-15 female for most transceiver connections), DTE (DB-15 male-AUI for direct connects), ST (Ethernet multi-mode Fiber ST), SC (Ethernet multi-mode Fiber SC), SMF (Ethernet single-mode Fiber) and RJ-45 (10BASE-T UTP and STP). They are shown in Figure 2.3. Each RPM is usually factory installed, or may be field installed by trained technicians as described in Section 3.0, Installation.

Figure 2.3: Magnum RPM Cards: RPM-BNC, RPM-AUI,

RPM-DTE, RPM-FST, RPM-FSC, RPM-TP, & PM-FP

Each of the individual RPMs are described in detail in this section.

2.3.1RPM-BNC

The Magnum RPM-BNC repeater module is equipped with a standard 10BASE2 coax connector. This RPM performs full IEEE 802.3 repeater functionality and is used for 10BASE2 ThinNet (commonly referred to as BNC) connections.

The RPM-BNC module is designed with a special switch -selectable internal

termination function that eliminates the need for a "tee" connector and a 50 ohm terminator. To

GARRETT

7

Page 12
Image 12
GarrettCom manual Magnum 700X Repeater Port Modules RPMs, Rpm-Dte, Rpm-Fst, Rpm-Fsc, Rpm-Tp, & Pm-Fp, Rpm-Bnc