Xerox SquareFold manual Problem solving

Page 17

Problem solving

3.Look for any jammed booklets within the SquareFold Trimmer Module paper path and remove them.

4.Check for loose trim scraps along the paper path and remove them.

5.Close the Top Left and Right Covers.

6.Empty the Trimmer Waste Container.

7.Ensure that the Trimmer Waste Container is completely pushed in/closed.

8.Ensure that all covers on the SquareFold Trimmer Module are closed.

9.If the SquareFold Trimmer Module Control Panel and/or the machine’s UI indicate there is a still a jam, recheck the SquareFold Trimmer Module (steps 1-8).

10.If necessary, open the finisher to look for jams/faults along the finisher path.

11.Follow the instructions displayed on the machine’s UI to resume printing/copying.

SquareFold Trimmer User Guide

13

Page 16 Page 18
Image 17
Page 16 Page 18
Contents User Guide Page Table of contents Ta b le o f c o n t e n t s SquareFold Trimmer User Guide OverviewOverview Main componentsMain components consist of the following Square fold mechanism is found in this areaBooklet to square fold area Paper pathDetects the lead edge spine of booklet and moves 2a.2b Control panelOverview Your requirements for the finished booklet job Square Fold SettingsSquare Fold Settings are found on the SquareFold Page Trimmer Mode Settings Lbs./g/m² Setting mm Printing full-page images on booklets Hints and tipsFollow these tips Jam clearance Problem solvingProblem solving Fault Codes Close the SquareFold Trimmer Module Top Left and Right Has a fault Possible cause Recommended solution Specifications Technical dataWeight Lb kg .8 mm height
Top Page Image Contents