82357B USB/GPIB Interface
3. Connecting the 82357B
3. Connecting the 82357B
N O T E
Plug the 82357B into a USB Port
Plug the 82357B USB cable into an available USB port on your PC or on a supported USB hub. To connect to USB hubs, see the 82357B User's Guide. The picture shown below is for illus- tration purposes only. It is not necessary to connect the 82357B to any GPIB instruments at this time.
Observe the 82357B LEDs
Observe the three LEDs on the 82357B. Initially, only the red FAIL LED should be illuminated. After 10 seconds, all three LEDs should be illuminated to show that the 82357B has been installed, and is configured for use with the IO Libraries.
READY LED
FAIL LED
82357B
USB Cable
ACCESS LED
If any LED is not illuminated after 10 seconds, see Chapter 3,
“Troubleshooting the Agilent 82357B” in the 82357B User's Guide for more information.
82357B Quick Start Guide | 5 |