Xerox D63-069-00 manual Authorize the Idaxfc Proc, Authorize the Idaxfc program module

Description

FSS printer definition

Printer mode, accepts both line and page data Universal Character Set

Recommended route code destination used to direct output to this printer.

Keyword indicates printer should be started by op- erator START command.

Output class to be initially processed. Work selection criteria.

Authorize the IDAXFC PROC

Permit the IDAXFC program module to run in KEY=1 by adding an entry to the Program Properties Table (PPT) found in the SYS1.PARMLIB SCHEDXX member. The following example indicates the attributes required for the PPT:

PPT PGMNAME(IDAXFC)	/* PROGRAM MODULE		*/
CANCEL	/* CAN BE CANCELLED		*/
KEY(1)	/*	PROTECTION KEY	*/
AFF(NONE)	/*	NO PROCESSOR AFFINITY	*/

Dynamic activation of PPT table entries can be performed on newer MVS and OS/390 sys- tems using the authorized MVS Operator SET SCH command, e.g. to activate member SCHED04, use the following command sequence:

T SCH=04,L

Authorize the IDAXFC program module

Permit the idaXFC PROC/program read access to fonts, XES forms and overlays from the system libraries in RACF or other security system(s). Where user libraries will be used, the security rules of the job submitter and the idaXFC will be in effect for these datasets.

Create/Modify IDAXFC Program Security Rules

A number of datasets are dynamically allocated during the operation of the IDAXFC which are used for logging. Permit the IDAXFC program to write on a non-temporary volume by creating/modifying system access security rules (if required). The high level dataset qual- ifier used during dataset creation is supplied in the IDAXFC profile DDNAME parameter.

JES2 Installation

The following modifications must be included in the JES2 parameter deck to define an FSS system and any associated printers.

The recommended JES printer definitions keywords are listed below:

Keyword

MODE=FSS

PRMODE=(LINE,PAGE)

UCS=0

ROUTECDE=dest

DRAIN

CLASS=x

WS=

Note: Up to 2200 printers can be controlled by a single FSS. The actual number of print- ers that can be active simultaneously will depend on the processor size and print workload. Multiple FSS definitions could therefore be required.

1.Generate the FSS definition(s)

The FSSNAME and PROC name in the following example are both assumed to be

IDAXFC.

The following example indicates a JES2 FSS definition for JES2 versions prior to 4.1.

ida XFC Spool File Converter Installation Procedure 19