Xerox D63-069-00 manual Display, IdaXFC Spool File Converter Operator Commands

•Stop (P)

This command performs an orderly shutdown of the entire idaXFC system. This command is intended to be used during termination of the system (e.g. prior to an IPL). The shutdown command will take affect when all printing presently in progress is terminated. When more than one Stop command is entered, an orderly "forced" termination of idaXFC system is performed, which will interrupt any printing/conversion presently in progress.

•Stop Printer

This command performs an orderly shutdown of the printer.

•Force Printer

This command performs a forced shutdown of the printer. A VTAM UNBIND request is issued to the printer. This command should be used to terminate printer communi- cation in the event of a error situation

•Dump Printer

This command is used only for diagnostic purposes, and causes a display of internal control blocks. Processing is not affected with the use of this command.

•DISPLAY

This command can be used to display the printer status and configuration (using op- tional keywords). Optional keywords that can be supplied are:

*Printers

Displays a summary status of all printers

*Default

Displays the default profile configuration keywords

*Single printer

Displays status and configuration information for a single printer

*Level

Displays the product software level

•ADD

This command allows the addition of a new printer definition without requiring termi- nation of the idaXFC. Prior to using this command, the printer to be defined must be defined to the VTAM application. The prt parameter refers to the printer name that will be used.

When printers are defined, only the printer name and printer related configuration val- ues are supplied. All other values are set to the configuration supplied on the default statement or actual keyword defaults (where no default value has been requested). Keyword values can be altered using the modify operation.

Note: Printer add and set commands first take effect when the printer is stopped and restarted, and are in effect until the print system is terminated, or the next add or modify command is entered.

•MODIFY

Any printer configuration value can be altered dynamically using the set command. Values will first be used when the printer is stopped and restarted. In addition, the Set default keyword can be used to alter the configuration values supplied for the default statement.

idaXFC Spool File Converter Operator Commands 35