Belkin F1DA208Z manual Keyboard Hot-Key-Command Shortcuts, AutoScan Time

Using your PRO3 KVM Switch

AutoScan Time

This specifies the amount of time the PRO3 KVM Switch remains on a server before switching to the next server while in AutoScan mode. You can set the scan-time interval to anywhere between 05 and 99 seconds. To change the scan time, use the arrow keys to navigate to the “Scan Time” field and hit “Enter”, and then type the desired time interval (in seconds).

To enable AutoScan, refer to the hot-key section on page 22. Note: The number keypad will not function in the OSD.

Keyboard Hot-Key-Command Shortcuts

Below is a complete list of hot-key commands that can be used for your PRO3 KVM Switch:

Command	Function
Space Bar	Activate OSD
	Previous host
	Next host
[01,02.,,,16] port	Non-daisy-chain KVM switch
[00,01.,,,15] BANK	Daisy-Chain Config: First and second digit
[01,02.,,,16] port	specifies BANK
	Daisy-Chain: Third and fourth digit specifies
	number
PgUP	Previous BANK
PgDown	Next BANK
B	Turn on/off beep while in AutoScan mode
S	Enable/disable OSD security
P	Turns console screen “Off”, and prompts for
	user name and password if security is enabled
A	Administrator activates AutoScan
Delete	Administrator sets the OSD back to factory-
	default values (except for security settings)

Note: You will have approximately three seconds to complete each hot-key sequence.

1

2

3

4

5

6

7

8

section

28