Sta L L At I O N, Pre-Configuration

I N STA L L AT I O N

Pre-Configuration

Where to Place the PRO2:

The enclosure of the PRO2 is designed for standalone or rack-mount configuration. The 8- and 16-port PRO2s are natively rack-mountable in standard 19-inch server racks. Rack-mount hardware is included with these switches for a study rack installation. An optional rack-mount kit (F1D005) is available for use with the 4-Port PRO2.

Consider the following when deciding where to place the PRO2:

•whether or not you intend to use the direct-access port selectors;

•the lengths of the cables attached to your keyboard, monitor, and mouse;

•the location of your CPUs in relation to your console;

•and the lengths of the cables you use to connect your computers to the PRO2.

Cable Distance Requirements:

For PS/2 computers:

VGA signals transmit best up to 25 feet. Beyond that length, the probability of video degradation increases. For this reason, we recommend that the length of the cables between the PRO2 and the connected computers does not exceed 25 feet.

Note:

If you need your console to reside further than 25 feet from the PRO2, we recommend using the Belkin CAT5 Extender (F1D084) with a standard CAT5 UPT cable. By using this device, you may increase the distance between your PRO2 and your keyboard, mouse, and monitor by as much as 500 feet without risking signal degradation.

For USB computers:

USB signals can be transmitted up to 15 feet between the PRO2 and the CPU. Beyond 15 feet, the probability of signal failure is likely, and this may cause the device to fail.

Cautions and Warnings:

Avoid placing cables near fluorescent lights, air conditioning equipment, or machines that create electrical noise (e.g., vacuum cleaners).