Belkin user manual Powering up the Systems, Using Your PRO2

Page 18

U S I N G YO U R P R O 2

Powering up the Systems

Once all cables have been connected, power up the computers that are attached to the PRO2. All computers can be powered on simultaneously. The PRO2 emulates both a mouse and keyboard on each port and allows your computer to boot normally.

The computer connected to port “1” will be displayed on the monitor. Check to see that the keyboard, monitor, and mouse are working normally. Proceed to do this with all occupied ports to verify that all computers are connected and responding correctly. If you encounter an error, check your cable connections for that computer and reboot. If the problem persists, please refer to the Troubleshooting section in this manual.

Using Your PRO2:

Now that you have connected your Console and computers to your PRO2, it is ready for use.

Select connected computers by either the direct-access port selectors, located on the front panel of the PRO2, using the On-Screen Display, or by using hot key commands through the Console keyboard. It takes approximately 1-2 seconds for the video signal to refresh after switching computers. Re-synchronization of the mouse and keyboard signals also occurs. This is normal operation and ensures that proper synchronization is established between the Console and the con- nected computers.

16

Image 18
Contents OmniView TA B L E O F C O N T E N T S OverviewPackage Contents OmniViewFeature Overview E RV I E WLED Display Equipment RequirementsFront-Panel Push Button Seven-Segment LED DisplayOperating Systems Side View of the PRO2 Front View of the PRO2 Back View of the PRO2Specifications Max. Resolution 2048x1536@85Hz Bandwidth 400MHzPre-Configuration STA L L AT I O NCable Distance Requirements Step-by-Step Installation Guide Installing the PRO2 into a Server RackBracket Installation F1DA108T and F1DA116T only Single PRO2 Installation Connect the Computer PS/2 Installation USB InstallationConnecting Multiple PRO2s Daisy-Chaining USB cablesBank DIP Switch Configuration Chart DIP SWITCH#Before You Begin InstallationConnecting the Master Switch to the First Slave Switch Adding Additional Slave UnitsExample of Daisy-Chain Configuration Connecting the ComputersPowering up the Systems Using Your PRO2Selecting a Computer Using Keyboard Hot Key Commands + +I N G YO U R K V M SW I T C H AutoScan ModeSelecting a Computer Using Direct-Access Port Selectors Bank Up and Bank Down Scroll ButtonsKeyboard Hot Key Commands On-Screen Display Menu Control OSD Display Time To update the firmware, you will need the following itemsAutoScan Time Updating FirmwareConnecting Computers Setting the PRO2 into Flash ModeBelkin KVM Switches and Accessories OmniView KVM SwitchesMATRIX2 OmniView All-In-One KVM Cables USBOmniView Accessories and Adapters PRO2 Series FAQs PRO2 Series FAQs PRO2 Series FAQs Troubleshooting GeneralVideo Keyboard MouseMouse is not detected at boot-up USB WARRANTY, FCC , CE, Ices Statement F1DA104T, F1DA108T, F1DA116TP73782-A