Belkin PRO2 user manual Mouse is not detected at boot-up

Page 34

T R O U B L E S H O O T I N G

The mouse is not detected at boot-up.

• Check the cables and make sure that they are inserted correctly.

The computer boots up, but the mouse does not work.

•Make sure the mouse is plugged in properly.

•Make sure the mouse works when directly plugged into the computer. Rebooting may be necessary when trying this.

•Try a different mouse.

When I switch from one port to another, mouse movement is completely erratic.

•Make sure you do not have more than one mouse driver installed. Make sure that the driver is either for a standard PS/2 mouse or a Microsoft computer-compatible PS/2 mouse.

•Make sure you do not have any mouse drivers loaded in your CONFIG.SYS or AUTOEXEC.BAT files.

•Avoid moving the mouse or pressing the mouse button when switching ports on the PRO2.

•You can reset the mouse and resume proper mouse movement simply by unplugging the mouse from the front of the PRO2 for about 2-3 seconds, and then plugging it in again.

32

Image 34

Contents OmniView TA B L E O F C O N T E N T S OverviewPackage Contents OmniViewFeature Overview E RV I E WLED Display Equipment RequirementsFront-Panel Push Button Seven-Segment LED DisplayOperating Systems Side View of the PRO2 Front View of the PRO2 Back View of the PRO2Specifications Max. Resolution 2048x1536@85Hz Bandwidth 400MHzSTA L L AT I O N Pre-ConfigurationCable Distance Requirements Installing the PRO2 into a Server Rack Step-by-Step Installation GuideBracket Installation F1DA108T and F1DA116T only Single PRO2 Installation Connect the Computer PS/2 Installation USB InstallationConnecting Multiple PRO2s Daisy-Chaining USB cablesBank DIP Switch Configuration Chart DIP SWITCH#Before You Begin InstallationConnecting the Master Switch to the First Slave Switch Adding Additional Slave UnitsExample of Daisy-Chain Configuration Connecting the ComputersPowering up the Systems Using Your PRO2Selecting a Computer Using Keyboard Hot Key Commands + +I N G YO U R K V M SW I T C H AutoScan ModeSelecting a Computer Using Direct-Access Port Selectors Bank Up and Bank Down Scroll ButtonsKeyboard Hot Key Commands On-Screen Display Menu Control OSD Display Time To update the firmware, you will need the following itemsAutoScan Time Updating FirmwareConnecting Computers Setting the PRO2 into Flash ModeBelkin KVM Switches and Accessories OmniView KVM SwitchesMATRIX2 OmniView All-In-One KVM Cables USBOmniView Accessories and Adapters PRO2 Series FAQs PRO2 Series FAQs PRO2 Series FAQs General TroubleshootingVideo Keyboard MouseMouse is not detected at boot-up USB WARRANTY, FCC , CE, Ices Statement F1DA104T, F1DA108T, F1DA116TP73782-A