Belkin PRO2 user manual Connect the Computer PS/2 Installation, USB Installation

I N STA L L AT I O N

Connect the Computer:

PS/2 Installation

1.Using an OmniView KVM Cable (Belkin part# F3X1105-XX or F3X1835-XX-GLD), plug in the male VGA connector to the VGA port on the computer. Connect the other end (the female connector) of the VGA cable to the back of the PRO2 labeled "VGA 01".

2.Connect the PS/2 keyboard and PS/2 mouse connectors of the cable to the keyboard and mouse ports on the computer. Connect the other ends of the cables to the keyboard and mouse ports located directly underneath VGA 01 on the PRO2 (Belkin part # F3X1105-XX or F3X1835-XX-GLD).

3.Repeat steps 1 and 2 for each additional PS/2 computer you wish to connect.

VGA	VGA08	USB 08	VGA07	06 VGA 06	USB 06	VGA05	VGA04	USB 04	VGA03
	08	USB 07	07	06	USB 05	05	04	USB 03	03

VGA 02USB 02VGA01

02 USB 01 01

USB Installation:

Boot the computer you wish to connect via USB as you would normally with the keyboard, monitor, and mouse connected directly to the computer. After the operating system finishes loading, connect the PRO2 to the USB computer using the USB A-to-B cable that is part of your USB KVM Cable (Belkin part# F3X1962-XX or F3X1895-XX-GLD). Your computer should recognize your PRO2 and automatically install the HID USB driver if necessary. Once your computer finishes installing the USB driver, you can power down your computer to connect it to the PRO2.

11