Belkin 8820-00034-A user manual Information, FCC Statement, F6D4230-4

Page 95

Information

Table of Contents

sections

1

2

3

4

5

6

7

8

9

10

FCC Statement

DECLARATION OF CONFORMITY WITH FCC RULES FOR ELECTROMAGNETIC COMPATIBILITY

We, Belkin International, Inc., of 501 West Walnut Street, Compton, CA 90220, declare under our sole responsibility that the device,

F6D4230-4

complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Caution: Exposure to Radio Frequency Radiation

The device shall be used in such a manner that the potential for human contact during normal operation is minimized.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body.

Federal Communications Commission Notice

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try and correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the distance between the equipment and the receiver.

Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

For IEEE 802.11b/g products in the USA market, only channels 1 through 11 can be operated. Selection of other channels is not possible.

This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter.

Enhanced Wireless Router

93

Image 95
Contents Enhanced Wireless Router Table of Contents Introduction Advantages of a Wireless NetworkIntroduction Placement of your Enhanced Wireless RouterImportant Factors for Placement and Setup Router PlacementCordless Phones Choose the Quietest Channel for your Wireless NetworkSecure Connections, VPNs, and AOL Product Overview Product FeaturesProduct Overview System Requirements Package ContentsSetup Assistant Software System Requirements Knowing your RouterRouter/Power Status Wireless SecurityWireless-Computer Status Wired-Computer StatusInternet Status Modem StatusIi. Restoring the Factory Defaults Connections to Wired Computers GrayReset Button Red Resetting the RouterModem Requirements Connecting and Configuring your RouterSetup Assistant Ethernet USB Connecting and Configuring your Router Setup CD Connecting and Configuring your Router Confirmation Screen Progress Screen Checking Settings Verifying Hardware Connections Requesting Internet Account Info if needed Naming your Wireless NetworkConfiguring the Router Checking Internet Connection Congratulations Troubleshooting Connecting and Configuring your Router Hardware Connections Follow the Quick Installation Guide Alternate Setup MethodLogging into the Router Logging out of the Router Alternate Setup MethodUnderstanding the Web-Based Advanced User Interface Home Button Login/Logout ButtonInternet-Status Indicator Quick-Navigation LinksLanguage LAN SettingsInternet Settings FeaturesSetting your Connection Type Change WAN MAC Address Host NameISP Gateway Address IP AddressSubnet Mask Setting your ISP Connection Type to PPPoE IP Assigned by ISP PasswordService Name User NameAlternate Setup Method Connection ID Optional Pptp PasswordService IP Address Pptp AccountDisconnect after X minutes… L2TP PasswordL2TP Account Setting Custom Domain Name Server DNS Settings Entering a Specific MAC Address Configuring your WAN Media Access Controller MAC AddressCloning your MAC Address Viewing the LAN Settings Using the Web-Based Advanced User InterfaceChanging LAN Settings Using the Web-Based Advanced User InterfaceLocal Domain Name Dhcp ServerIP Pool Lease TimeViewing the Dhcp Client List Changing the Wireless Network Name Ssid Configuring the Wireless Network SettingsOff Changing the Wireless ChannelUsing the Wireless Mode Switch Extension Channel20MHz only Using the Broadcast Ssid Feature Protected Mode SwitchUsing the Bandwidth Switch 802.11e/WMM QoS SwitchUsing the Web-Based Advanced User Interface Using the Web-Based Advanced User Interface WPA2 Requirements Setting WPA/WPA2 Encryption Setting WEP Encryption Using a Hexadecimal Key Using the Access Point Mode Setting up an Allow Access List Setting MAC Address ControlSetting up a Deny Access List Configuring the Firewall Choosing an Application Configuring Internal Forwarding SettingsManually Entering Settings into the Virtual Server Setting Client IP Filters Enabling the Demilitarized Zone DMZ Setting up the Router’s Dynamic DNS Update Client Using Dynamic DNSUtilities Restarting the Router Restarting the Router to Restore Normal OperationRestoring Factory Default Settings Saving a Current Configuration Using the Web-Based Advanced User Interface Restoring a Previous Configuration Using the Web-Based Advanced User Interface Downloading a New Version of Firmware Updating the FirmwareChecking for a New Version of Firmware Using the Web-Based Advanced User Interface Updating the Router’s Firmware Using the Web-Based Advanced User Interface Changing the Login Time-Out Setting Changing System SettingsSetting or Changing the Administrator Password Enabling Remote Management Setting the Time and Time ZoneEnabling/Disabling UPnP Enabling/Disabling Auto Firmware UpdateManually Configuring Network Settings in Mac OS up to Manually Configuring Network SettingsManually Configuring Network Settings Manually Configuring Network Settings Manually Configuring Network Settings Manually Configuring Network Settings in Windows 98SE or Me Internet Explorer 4.0 or Higher Recommended Web Browser SettingsNetscape Navigator 4.0 or Higher Recommended Web Browser SettingsSolution TroubleshootingProblem Troubleshooting Setup Assistant cannot find my Router Setup Assistant cannot connect my Router to the Internet Troubleshooting Can’t connect to the Internet wirelessly Troubleshooting Troubleshooting C3 03 0F AF 4B B2 C3 D4 4B C3 D4 E7 E4 = 128-bit key Click OK, and then Apply to save the settings Do Belkin products support WPA/WPA2? Troubleshooting Troubleshooting Troubleshooting Technical Support Wireless Comparison ChartWhat’s the difference between 802.11g and draft 802.11n? Federal Communications Commission Notice InformationFCC Statement F6D4230-4Canada-Industry Canada IC InformationModifications Europe-European Union NoticeBelkin International, Inc., Limited 1-Year Product Warranty How state law relates to the warranty