3M M2256PW manual Regulatory Information, Regulatory Agency Approvals, Fcc-B

Page 40

40	3M™ Multi-touch Display M2256PW User Guide

APPENDIX C

Regulatory Information

Regulatory Agency Approvals

Your product complies with the following regulatory standards:

•FCC-B

•CE

•UL60950/IEC60950/EN60950 certified in compliance with the CB test scheme

•RoHS/WEEE directives

This equipment has been tested and found to comply within limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in residential installations. This equipment generates, uses and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio or television equipment reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Move the equipment away from the receiver.

•Consult the dealer or an experienced radio/television technician for additional suggestions.

3M Touch Systems, Inc. Proprietary Information – 37531 Rev D

Image 40

Contents 3M Touch Systems, Inc. Proprietary Information 37531 Rev D 3M Multi-touch Display M2256PW User Guide Contents Appendix B 3M PX Serial Controller Communications Appendix a 3M PX USB Controller CommunicationsAppendix C Regulatory Information Important Safety Information IntroductionOverview Intended UseExplanation of Signal Word Consequences Important Notes Maintaining Your Touch DisplayTouch Sensor Care and Cleaning 3M Touch Systems Support ServicesContact 3M Touch Systems Setting up Your M2256PW Multi-touch Display System RequirementsUnpacking Your Touch Display Cables Included with Your M2256PW Multi-touch DisplayTesting the M2256PW Multi-touch Display Connecting the Touch DisplayArm Mounting Option Using the Standard Controls for the Video Card Applicable Display Mode and Refresh Rate Refresh Rate HzVideo Card Requirements Supported Video Display Modes and Refresh RatesConfiguring the Display Settings Multimedia FeaturesAccess to the Video Controls Menu/Select Down Up Auto/Exit Power LEDAdjusting the M2256PW Video Display Choices DescriptionAudio Tools Enabling Your M2256PW Multi-touch Display Windows 7 USB CompatibilityAll Other Platforms Multitouch Application SupportInstalling 3M MicroTouch Software Video Alignment3M Multi-touch Display M2256PW User Guide Overview of USB Firmware Communications 3M PX USB Controller CommunicationsCommunication Basics Command Set Set Feature CalibrationReceiving Reports from the Controller HID Class RequestsCalibration Setup Stage Offset Field Size Value Description Calibration Response Command Status Byte DescriptionDetermining Target Areas Data Stage Offset Field Size Value DescriptionGet Feature GetStatus Get Feature GetMaxCount Power On Check Bit Fields Bit Number DescriptionValid Command Status Field Entries Response Description Setup Stage Offset Field Size Value DescriptionReset Setup Stage Offset Field Size Value Description Set Feature ResetReset Data Stage Offset Field Size Value Description Set Feature -Restore Defaults Coordinate Data MultiTouch Digitizer mode Async ReportAsynchronous Reports Offset Field Size Value DescriptionTouch Report Structure Offset Field Value DescriptionOverview of Firmware Commands 3M PX Serial Controller CommunicationsController Default Settings Operating ModeCommunicating with the Controller Communication ParametersSending Commands to the Controller Receiving Responses from the ControllerFirmware Commands Controller InitializationCommand Code Description CalibrateMDU SOH CxcrGuidelines for Calibrate Command Calibrate ProcedureMode Down Up Mode InactiveMode Stream Get CopyrightName Command Null CommandSoft Reset Output IdentityRestore Defaults Operating Parameter DefaultUnit Type SOH RdcrBit Description Touch Data FormatData Sequence Bits Data Sequence Bits Regulatory Agency Approvals Regulatory InformationFCC-B FCC Warning CE Conformity for Europe