Standard/non-standard code setting mode
Standard/non-standard code settings for control codes can be changed using the control code setting command.
Standard/non-standard specifications
| | | |
Type | Operation | | Default |
Standard | The following control codes are set as standard codes. | Standard |
code | Control code | Binary | code |
setting | STX | 02H | setting |
| ETX | 03H | |
| ESC | 1BH | |
| ENQ | 1BH | |
| CAN | 18H | |
| NULL | 00H | |
Non-stan- | The following control codes are set as non-standard codes. | |
dard code | Control code | Binary | |
setting | STX | 7BH({) | |
| ETX | 7DH()) | |
| ESC | 5EH(^) | |
| ENQ | 40H(@) | |
| CAN | 21H(!) | |
| NULL | 7EH(~) | |
| Non-standard codes can be | changed using the user down- | |
| load setting command. | | |
Change standard/non-standard code setting
The standard code/non-standard code setting is changed by the DIP switch (DSW) settings when the power is turned on, and by button settings. The settings are enabled upon turning the power off.
(1)Non-standard code setting
DSW-1,2,3,4=(ON,ON,OFF,ON) + cover open + PRINT button + POWER
(2)Standard code setting
DSW-1,2,3,4=(ON,ON,OFF,ON) + cover open + FEED button + POWER
Processing setting
(STATUS LED flashes green)
Setting completes (STATUS LED lights green)
Notes: When the buzzer sound mode is enabled, the buzzer sounds upon startup. Release the PRINT/FEED button to stop the buzzer. To check the setting for the standard code/non-standard code setting mode, see chapter 6, Test Printing. To end standard code/non-standard code setting, confirm that the STATUS LED is on in green, then turn power off. After changing the standard code/non-standard code set- ting mode, be sure to restore the DSW to their original settings.After changing the dispenser operation mode setting, restore the DSW to their original settings.
