TRENDnet TW100-W1CA user manual Before Upgrade, Performing Firmware Upgrade

Page 32

FIRMWARE UPGRADE

System Requirements

??One free COM port on PC.

??A pin-to-pin RS-232 cable. One end is 9 pin male connector, the other end is 9 or 25 pin female connector depends on the COM port.

??FWLOAD.EXE : This is an auxiliary program for firmware upload.

??FIRMWARE.BIN : This is a firmware image file.

??LOAD.EXE: This is the main program.

The above three files MUST reside in the same subdirectory.

For better disk access speed, it is recommended that you copy these two files to your hard disk before uploading them to the product.

Before Upgrade

Close all other Windows programs and power off this device.

Performing Firmware Upgrade

1.Connect the RS-232 cable from the Console port of the device to the PC’s COM port .

2.Create a temporary folder in your system (e.g. NewFirmware.). Copy the downloaded firmware file (should be a compressed file, e.g. FW3_20.EXE) to this temporary folder. Decompress the file to any desired folder.

3.Open the folder with the new firmware and double -click LOAD.EXE.

Figure 21

4.Select the COM port that is connected to the device and click the Start button.

-28 -

Image 32

Contents TW100-W1CA FCC Certifications Table of Content Terminal CommandChanging Password Introuction Sample ApplicationParts Names and Functions FeaturesLED Indicators on the Front Panel Ports on the Rear Panel Color Status Indicator Glowing Dim Flashing Power ErrorLED Indicators Local LinkSystem Requirements Factory Default Settings PasswordLocal and Global Port Addresses Information from ISPHow to start ConfigurationConfiguration in GUI Management PPPoE functions Firmware Version Read-onlyDomain Name2 Local Port SubNetmask? Do not distribute IP address to local computers3 ? Distribute IP addresses to local computersNumber of IP address in pool Global PortContinuous IP address pool starts at Virtual Server Packet Filters Network Adapter Address Filter TCP/UDP Port Filter Configuration in Terminal Program Mode How to start HyperTerminalHow to start Telnet Go to Start?RunStarting the Configuration Terminal Command PasswdShow ExampleSet Vserv Release ? IP address of the local Web serverRenew UserPing SessionFilter MAC address filterIP address filter Remote serverExample 1 Allow users to access Web service only Port FilterPerforming Firmware Upgrade Firmware UpgradeBefore Upgrade Page Page Using Terminal Mode Changing PasswordUsing GUI Forgot your password? What is PPPoE? How can I know I am using PPPoE?PPP Over Ethernet Pppoe Checking PPPoE ConnectionsCant find the product using the GUI Setup Software FAQFactory Reset IP address conflict My Internet application wont workPage Page Can not access the Internet Check the status of this product Check the physical connectivity of local networkCheck the physical connectivity of the broadband device Diagnosis TCP/IP Network DiagnosisPING.EXE ISP Connectivity Checkup Internet Connectivity CheckupGetting Technical Support Appendix a Specifications Appendix B Supported Internet Applications AOE