TRENDnet TW100-W1CA user manual Changing Password, Using GUI, Using Terminal Mode

Page 35

CHANGING PASSWORD

The device has no password at default. It is recommended that you change the default passwords to ensure that someone cannot adjust the devices settings.

Using GUI

1.Start this device by running setup.exe as described in the chapter titled “Configuration”.

2.Check “Change Administrator’s Password.

3.Enter the desired new password in “New Password”. Enter the new password again in the “Confirm New Password” field.

Please note that the password is case sensitive.

Figure 25

Using Terminal Mode

Refer to the previous section titled “Configuration in Terminal Program” for terminal emulation. After seeing the following command prompt, follow the instructions in italic fonts to setup the new password. Please note that passwords are case sensitive.

command>passwd

Please type old password: **** Type in old password and press

<Enter>

- 31 -

Image 35
Contents TW100-W1CA FCC Certifications Terminal Command Table of ContentChanging Password Sample Application IntrouctionParts Names and Functions FeaturesLED Indicators on the Front Panel Ports on the Rear Panel Local Link Color Status Indicator Glowing Dim Flashing PowerError LED IndicatorsSystem Requirements Information from ISP Factory Default SettingsPassword Local and Global Port AddressesHow to start ConfigurationConfiguration in GUI Management PPPoE functions Firmware Version Read-onlyDomain Name2 ? Distribute IP addresses to local computers Local PortSubNetmask ? Do not distribute IP address to local computers3Number of IP address in pool Global PortContinuous IP address pool starts at Virtual Server Packet Filters Network Adapter Address Filter TCP/UDP Port Filter How to start HyperTerminal Configuration in Terminal Program ModeGo to Start?Run How to start TelnetStarting the Configuration Passwd Terminal CommandExample ShowSet Vserv ? IP address of the local Web server ReleaseUser RenewSession PingMAC address filter FilterRemote server IP address filterPort Filter Example 1 Allow users to access Web service onlyPerforming Firmware Upgrade Firmware UpgradeBefore Upgrade Page Page Using Terminal Mode Changing PasswordUsing GUI Forgot your password? Checking PPPoE Connections What is PPPoE?How can I know I am using PPPoE? PPP Over Ethernet PppoeCant find the product using the GUI Setup Software FAQFactory Reset My Internet application wont work IP address conflictPage Page Can not access the Internet Check the status of this product Check the physical connectivity of local networkCheck the physical connectivity of the broadband device TCP/IP Network Diagnosis DiagnosisPING.EXE Internet Connectivity Checkup ISP Connectivity CheckupGetting Technical Support Appendix a Specifications AOE Appendix B Supported Internet Applications