Setting mode 8 to on

7. Detailed Description

7.5Manual restart in operation mode 8

Note: Although this feature activates the general cut-off, it is not a dedicated ”safety-function” of the type listed above. When the error message shown above is dis- played, the sensor must be exchanged by service per- sonnel.

Restart after power failure

MultiTemp III automatically restarts after a power failure. Make sure that this automatic restart will not cause a dange- rous situation to arise.

The unit can be restarted manually instead by pressing (see Section 7.5).

MultiTemp III is factory set to normal mode. Normal mode means that the unit automatically re-starts after power failu- re. As most modern electrophoresis power supplies automati- cally restart after short power failures, we strongly recom- mend that you leave MultiTemp III set in its normal mode.

However, if automatic re-start is inconvenient, the unit can be restarted manually by setting Operation mode 8 to ON, follow the procedure below:

1.Press simultaneously with the mains switch. Then

press again until ”mode 8” is selected.

2.Press to select ”ON” instead of ”OFF”. (”OFF” is factory set)

3.	Confirm by pressing	when the display is flas-
	hing.

4.Wait until the display shows the actual temperature.

5.Switch off the unit using the mains switch.

The operation mode is now changed to ON.