TRENDnet 18-1106-33 user manual Operation, Start-up

Page 11

4. Operation

4.1 Start-up

4. Operation

9

10

8

7

6

1

2

3

4

5

Fig. 2. Front panel of MultiTemp III.

1.	Mode selector	6.	Mains switch
2.	Set value down	7.	Control lamp cooling on/off
3.	Set value up	8.	Display
4.	Enter	9.	Heater control sign
5.	Reset	10. Display

Before switching on, confirm that the outlet and inlet nozzles are either firmly connected to external equipment or to each other and that the tubing is secured with hose clamps.

Switch the power on at the mains switch.

The version number of the software is briefly shown on the display.

After starting the unit, the pump will circulate the liquid to

9

Image 11

Contents MultiTemp Important user information Contents Page Introduction Safety informationSafety precau- tions Safety standards Pump motor protection Safety features General cut-offRestart after power failure Protection against over-heatingUnpacking and installation InstallationInstallation Mains connection Start-up OperationSetting the temperature limit Tempera- ture setting limit Tempera- ture setting Tempera- ture correction value Operation Error messages Trouble shootingDisposal MaintenanceGeneral Push Detailed Description Detailed Description Description of safety features General cut-off Protecting the pump motor Accurate Setting of Temperature LimitSetting mode 8 to on Manual restart in operation mode Restart after power failureResetting mode 8 to OFF Technical specifications ambient temperature 20 C Technical specificationsOrdering information Accessories Quantity Code NoPage Short instructions