TRENDnet TPE-80WS manual Troubleshooting, Q1 How do I configure TCP/IP settings on my computer?

Page 6

Troubleshooting

Q1: How do I configure TCP/IP settings on my computer?

1.Go into the Control Panel and double- click the Network Connections icon, right-click the Local Area Connection icon and then click Properties.

2.Click Internet Protocol (TCP/IP) and then click Properties. Then click on Use the following IP address, and make sure you assign your network adapter an IP address in the subnet of 192.168.223.x.

Q2: I typed http://192.168.223.100 in my Internet Browser's Address Bar, but an error message says “The page cannot be displayed.” How can I get into the TPE- 80WS's web configuration page?

A2: First, check your hardware settings again by following the instructions in section 2. Second, make sure the POWER and LINK/ACT lights are lit. Third, make sure the TCP/IP settings are configured properly (see Q1). Fourth, since the PoE Switch’s default IP address is 192.168.223.100, make sure that no other network devices are assigned an IP address of 192.168.223.100.

Q3: If my network's IP is different than the PoE Switch's range, what should I do?

A3: You should still configure the PoE Switch first. After all the settings are applied, go to the PoE Switch's configuration page, click on IP settings and change the IP address of the PoE Switch to match your network's IP.

4

Image 6
Contents TPE-80WS Table of Contents Package Contents Before You StartHardware Installation Configure the Power Over Ethernet PoE Switch Troubleshooting Q1 How do I configure TCP/IP settings on my computer?Default password is admin Certifications AdvertenciaTRENDnet Technical Support
Related manuals
Manual 10 pages 9.87 Kb