20Control Panel Operations
Micro feed
Use the following operation to feed the paper in very small increments. This makes it possible to align the print head exactly where you want it.
❏Make sure the printer is
❏While holding down ON LINE, press PAPER FEED to feed the paper forward or PITCH to feed the paper backward.
Setting the top of form position
The current position of paper loaded in the printer is automatically set as the top of the page whenever you turn power on. You can also use the following procedure at any time to specify a different position as the top of the page.
❏Make sure the printer is
❏Use the micro feed operations (see above) to move the paper so that the print head is located where you want the new top of form position to be.
❏While holding down PITCH, press PAPER FEED.
The printer will beep once to indicate that a new top of form position has been set.
Tear-off function (fanfold paper)
This procedure feeds fanfold paper to a position where it can be torn off easily.
❏Check to make sure that the printer is
❏Press the FONT button to perform the long
The long
The short
❏Pull the paper against the tear assist edge to tear it off.