TRENDnet TEW-P1P, TEW-P1U Trademarks, Copyright, FCC Compliance Notice Radio Frequency Notice

Page 5

Trademarks

NetWare is a registered trademark of Novell Inc and Windows 95/98/Me and Windows NT/2000/XP are registered trademarks of Microsoft Corp. All other brands and product names are trademarks of their respective companies.

Copyright

No part of this publication may be reproduced in any form or by any means or used to make any derivative (such as translation, transformation or adaptation) without the express written consent of the manufacturer as stipulated by the United States Copyright Act of 1976.

FCC Compliance Notice: Radio Frequency Notice

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1.This device may not cause harmful interference.

2.This device must accept any interference received, including interference may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: (1). Reorient or relocate the receiving antenna, (2). Increase the separation between the equipment and receiver, (3). Connect the equipment into an outlet on a circuit different from that to which the receiver is connected, (4). Consult the dealer or an experienced radio/TV technician for help.

Important Note:

FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. In order to avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to the antenna shall not be less than 20 cm (8 inches) during normal operation.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.”

Part No. P1PU-V1.1

3

Image 5
Contents Page Page Network Print Monitor Overview Upgrading the Print Server from Psadmin Copyright TrademarksFCC Compliance Notice Radio Frequency Notice Important Note FCC Radiation Exposure StatementWireless Specifications Network configurationProduct Overview Network ManagementBefore you start, you should prepare Components and Features Wireless Print serverHardware Installation Ad-hoc PEER-to-PEER Mode Wireless Network EnvironmentSetup Operating Function Remarks System Configuration Solution TablePreparation Supported NetworksComment Setup Utility for Windows-basedTo install Wizard, please follow the directions listed below Installing the Setup WizardPage Page Page Page Page Page Page Page Using PSAdmin TCP/IP Wizard WizardNetWare Wizard Manual Setup Specify an IP address Properties -TCP/IP OptionsObtain an IP address from a Dhcp server Upgrade Refresh ResetMultiple Print Queues Configuration Procedure Uninstalling the PSAdmin on Windows PCWindows NT/2000/XP/2003 IPP OverviewPage System Requirements HP Web JetAdmin OverviewConfiguring and Modifying a Device Installing HP Web JetAdminConfirming Installation and Supply Access Removing HP Web JetAdmin Utility Status Menu Using Embedded Web ServerOverview System Status Printer Status Wireless StatusTCP/IP Status Netware Status NetWare NDS Setting General SettingsNetWare Bindery Setting Snmp StatusAppleTalk Status Setup Menu Re-type Password System SetupBasic Settings Wireless SetupWEP Settings NetWare Setup Installing Print Server on NetWare 4.x/5.x Select NCF files options Select Edit AUTOEXEC.NCF file Installation ProcedureSnmp Setup System.sysContact Snmp.snmpEnableAuthenTrapsSystem.sysName System.sysLocationAppleTalk Setup Recommended Network Print Monitor Setting Up a Macintosh ComputerRestart the computer TCP/IP Protocol InstallationNetBEUI Protocol Installation IPX/SPX-compatible Protocol InstallationSelect Printer and Properties Windows 95/98/Me/NT/2000/XP Installation ProcedurePage Basic TCP/IP Installation Overview TCP/IP LPR Port Printing InstallationAssigning an IP Address Windows NT LPR Port Printing InstallationUse the Network Print Monitor utility Run Add PrinterWindows 2000/XP Standard TCP/IP Port Printing Installation Run Add Printer, Click Next Page Page Login root Type arp -s IP address Print server‘s node ID Unix InstallationSCO Unix OpenServer Type tftp Print server‘s IP addressIs xxxx a remote printer or a local printer r/l --------- r SUN SolarisIBM AIX Type lpadmin -pprinter-1 -s Print server‘s IP addressType enable printer-1 For example enable printer-1 Select Standard Process Open Printer ConfigurationRedhat Linux Click New button Click Forward button Queue Type field, choose Networked Unix Printer field, choose Postscript Printer Printer Connection Type, select On Remote Server UnixWareType tftp -i print server’s IP address put mpsXX.bin Upgrading the print server from PSAdminType tftp print server’s IP address Upgrading the print server from Unix Through TCP/IPUpgrading the print server from Browser Click Upgrade form Browser and select the firmware file Done Print Port Related Problems General Troubleshooting OverviewPower Related Problems Multi-Segment Frame Type 802.2 Installation Windows 95/98/Me/NT/2000/XP TroubleshootingSelect Control Panel Frame Type field, select EthernetMoving the print server to a New Segment Print Server Reconfiguration Procedure on Windows 95/98/MePrint server Reconfiguration Procedure on Windows NT Moving Your Computer to a New Segment Novell NetWare TroubleshootingTCP/IP Troubleshooting Page Page Appendix Diagnostic ModeLoad Default Value Question C Frequently Asked QuestionsQuestion B Question F Question DQuestion E Panasonic KX-P6100/6300/6500 Additional Installation Instructions
Related manuals
Manual 9 pages 59.8 Kb