TRENDnet TV-IP100 manual Adjust Internet Camera Focus, Specification

Page 49

F Adjust Internet Camera Focus

To adjust the focus of the lens, you need to turn the lens slowly in either clockwise or anti-clockwise direction until the desired image appears. DO NOT over turn the lens in either of the directions as it will be out of focus.

Note:

You can further adjust the Wireless Internet Camera's image quality through System Administration – Image of Web Configuration. Please refer to Web Configuration section for further details.

Warning

Direct exposure to sunlight may cause permanent damage to the CMOS sensor. Therefore do not expose the Internet Camera’s lens directly to sunlight. When operation is required in glaring light environment, it is recommended to use an iris lens.

The Internet Camera is designed for indoor usage and if your application requires prolong exposure to sunlight, a sun visor is recommended to protect the Internet Camera.

G Specification

Video Specification

Resolution:

640 x 480 pixel

Sensor:

1/3” color CMOS sensor

Gain control:

Automatic

Exposure:

Automatic

White Balance:

Automatic

Shutter:

Electronics 1/60 ~ 1/15000 sec

Minimum Illumination:

2.5 lux@f1.4, 3000K color

Focal Length:

6.0 mm

Aperture:

F=1.8

Signal/ Noise ratio

57dB

Focus Extent:

20 cm - ∞

Lens mounting:

Fixed board lens

Image (Video Setting)

 

Image compression:

JPEG

Frame rate:

20fps@SIF, 6fps@VGA

Compression Rate selection:

Auto

Frame rate setting:

1, 5, 7, 15, 20, auto (depends on the

 

video format)

Video resolution:

320x240, 640x480

Brightness control:

Range 1- 128

Contrast control :

Range 1- 128

Saturation control:

Yes

96

97

Image 49
Contents Page Table of Contents Motion Record Schedule Record Manual Record About this GuideIntroduction Recommended PC or Notebook to Access the Internet CameraSystem Requirement Internet CameraSimple To Use Features BenefitsIPView SE Application Support Variety of Platforms Web ConfigurationRemote Utility Broad Range of ApplicationsPhysical Description Power LEDFront Panel Link LEDDC Power Connector Network Cable ConnectorReset Button Rear PanelBottom Panel Top PanelScrew Hole Unpacking the Internet Camera Connecting the Internet Camera to the Camera StandAttach the external power supply Hardware InstallationSecurity Software InstallationMain Menu Image System Administration System System AdministrationCamera Name AdminLocation IP Assignment Important InformationDynamic DNS DNS IP AddressLED Control Loading ActiveX FromSave/Cancel System Administration ImageVideo Resolution Compression RateSystem Administration Users Delete User System Administration DateTimeDateTime IP AddressTimeZone ProtocolTime Schedule FTP ServerManual Operation System Administration E-mailSystem Administration Tools System Administration InformationReset Factory ResetView Image ActiveX Mode View Image Java Mode Applications Internet Camera ApplicationSoho Applications Home Applications Internet Camera Application DiagramsApplication InstallationPage Page IPView SE Getting StartedIPView SE control panel How to Add a Camera Page Page Assign IP of New Camera How to Change CameraConnect the Image How to Connect / Disconnect the ImageDisconnect the Image How to Delete a CameraErase Camera Extra Information System ConfigureExtra Information Camera Setting Camera ConfigureMotion Setting Motion Record Update FirmwareSchedule Record Manual RecordAppendix Frequently Asked QuestionsPing Your IP Address Trouble Shooting Page Time Zone Table Installation Xplug Control InstallationPage Specification Adjust Internet Camera FocusEMI Numbers HGlossary of TermsDNS ISP RJ-45 connector is used for Ethernet cable connections TCP/IP