Chapter 3: Overlapping Powerline Networks
It is possible to create multiple powerline networks on the same electrical system separated and grouped by different network names/security keys. The powerline networks will work and communicate independently of each other which can provide security between different groups of powerline adapters. For example, if you have five powerline adapters (Adapter A, Adapter B, Adapter C, Adapter D, Adapter E), you can group Adapters A,B, and C together on one powerline network and group Adapters D and E on a different powerline network. Each group will use a different network name/security key.
Note: It is recommended that only a maximum of up to 4 powerline networks can be created per electrical system. Any additional powerline networks above the recommended result in significant degradation in powerline performance.
3.1 Move Powerline Adapters between different Powerline Networks
Use the procedures in Chapter 2: Product Installation, to connect one group of adapters, then you can carry out the procedures on another group of adapters to create multiple overlapping powerline networks. This procedure describes how to disconnect a powerline adapter from one powerline network and connect the adapter to a different powerline network.
Assuming all powerline adapters are
1.Push and hold the Sync button 
on Adapter B for 10 seconds and release it. All LEDs will turn off and turn back on. This will erase the current network name/security key assigned to Adapter B and disconnect from Adapters A and C.
2.Push and hold the Sync button 
on Adapter D for 2 seconds and release it. The PWR LED will start blinking.
3.Within 2 minutes (120 sec), push and hold the Sync button 
on Adapter B for 2 seconds then release it. The PWR LED will start blinking. This will establish connectivity between