TRENDnet SMT1000 operation manual Low Transfer Point

Function	Factory Default	Options	Description
	100 Vac:	86 Vac - 92 Vac	Set the transfer point lower if the utility voltage is
	92 Vac		chronically low and the connected equipment can
			tolerate this condition.This setting may also be adjusted
Low Transfer Point	120 Vac:	97 Vac - 106 Vac
			using the power quality setting.
	106 Vac
			Note: Use the Advanced Menus to configure this
	230 Vac:	196 Vac -208 Vac
	208 Vac		setting.
	100 Vac	N/A
Nominal Output	120 Vac	N/A	230 Vac models only: Set the nominal output voltage of
Voltage		• 220 Vac	the UPS to standby mode.
	230 Vac	• 230 Vac
		• 240 Vac
			Select the level of sensitivity to power events that the
			UPS will tolerate.
			• Normal: The UPS will go on battery power more
			often to provide the cleanest power supply to the
Transfer Sensitivity	Normal	Normal, Reduced, Low	connected equipment.
			• Low: The UPS will tolerate more fluctuations in
			power and will go on battery power less often.
			If the connected load is sensitive to power disturbances,
			set the sensitivity to Normal.
Low Battery Warning	120 sec	Set the value in seconds	The UPS will emit an audible alarm when the remaining
			runtime has reached this level.
Date of Last Battery	Date set at factory	Reset this date when the battery module is replaced.
Replacement
Audible Alarm	On	On/Off	The UPS will mute all audible alarms if this is set to Off
			or when the display keys are pressed.
Battery	On start up and every	• Never	The interval at which the UPS will execute a
		• Start up only
Self-Test Interval	14 days since the last
		• Frequency of test	self-test.
Setting	test
		(every 7 to 14 days)
Reset to Factory	No	Yes/No	Restore the UPS factory default settings.
Default

Smart-UPS 750/1000/1500/2200/3000 VA 100/120/230 Vac / 500 VA 100 Vac Tower 9