TRENDnet SMT1000 operation manual Overview, Product Description, Important Safety Messages

Page 3

Overview

Product Description

The APCby Schneider Electric Smart-UPSis a high performance uninterruptible power supply (UPS). The UPS provides protection for electronic equipment from utility power blackouts, brownouts, sags, and surges, small utility power fluctuations and large disturbances. The UPS also provides battery backup power for connected equipment until utility power returns to safe levels or the batteries are fully discharged.

This user manual is available on the enclosed CD and on the APC by Schneider Electric Web site, www.apc.com.

Important Safety Messages

Read the instructions carefully to become familiar with the equipment before trying to install, operate, service or maintain it. The following special messages may appear throughout this manual or on the equipment to warn of potential hazards or to call attention to information that clarifies or simplifies a procedure.

The addition of this symbol to a Caution product safety label indicates that a hazard exists that can result in injury and product damage if the instructions are not followed.

The following safety messages may appear throughout this manual to warn of potential hazards.

CAUTION

CAUTION indicates a potentially hazardous situation which, if not avoided, can result in equipment damage and minor or moderate injury.

CAUTION

CAUTION indicates a potentially hazardous situation which, if not avoided, can result in equipment damage.

Safety and General Information

Inspect the package contents upon receipt. Notify the carrier and dealer if there is any damage.

Read the Safety Guide supplied with this unit before installing the UPS.

Adhere to all national and local electrical codes.

This UPS is intended for indoor use only.

Do not operate this UPS in direct sunlight, in contact with fluids, or where there is excessive dust or humidity.

Be sure the air vents on the UPS are not blocked. Allow adequate space for proper ventilation.

The battery typically lasts for two to five years. Environmental factors impact battery life. Elevated ambient temperatures, poor quality utility power, and frequent short duration discharges will shorten battery life.

Connect the UPS power cable directly to a wall outlet. Do not use surge protectors or extension cords.

The equipment is heavy. Always practice safe lifting techniques adequate for the weight of the equipment.

The model and serial numbers are located on a small, rear panel label. For some models, an additional label is located on the chassis under the front bezel.

Always recycle used batteries.

Recycle the package materials or save them for reuse.

Smart-UPS 750/1000/1500/2200/3000 VA 100/120/230 Vac / 500 VA 100 Vac Tower

1

Image 3
Contents Smart-UPSUninterruptible Power Supply Page Product Description Important Safety MessagesSafety and General Information OverviewEnvironmental SpecificationsFront panel features Rear panel features 500 VA to 1500 VA modelsProduct Overview 2200/3000 VA 100 Vac 2200/3000 VA 230 Vac 3000 VA 120 Vac InstallationRear panel features 2200 VA and 3000 VA models 2200 VA 120 VacRear Panel Features OperationConnect Equipment Menu General Functions Using the display interfaceDisplay Panel Standard menusAdvanced menus ControlLog General Settings ConfigurationUPS Settings Start up SettingsLow Transfer Point Using the Main and Controlled Outlet Groups Main Outlet Group and Controlled Outlet GroupOverview Customize the Main and Controlled Outlet Groups Network Management Card SettingsEmergency Power Off Normally open contactsNormally closed contacts UPS is emits intermittent beeps TroubleshootingUPS does not provide expected backup time UPS displays a site wiring fault messageTransport the unit ServiceTwo Year Limited Factory Warranty EN 990-3534D 03/2013 APC by Schneider Electric Worldwide Customer Support