Fujitsu 1600 manual Ensuring Pen Accuracy, Using Hotpads

Ensuring Pen Accuracy

The Point 1600 pen tablet comes from the factory already calibrated so that the cursor location matches the pen tip location. If the cursor is not displayed directly under the pen tip when you touch the screen, then you should calibrate the pen tablet. For more information, see “Calibrating the Pen” on page 3-4.

Using Hotpads

The hotpads are controls along the lower edge of the Point 1600 screen that let you use functions and make adjustments to the system. You use the hotpads by tapping them with the pen. The following figure shows the name of each hotpad. Table 2-2 shows the function performed when you tap each hotpad.

Display Select

Contrast Down Contrast Up

Speaker VolumeRight Mouse ButtonBrightness

	Table 2-2 Hotpads
Speaker		Tap this hotpad to change the speaker volume to
Volume		the low, medium, high, or off setting. (Note that the
		sound level may also be controlled by settings in
		your application or operating system software.)
Display Select		Tap this hotpad to select an external monitor, the
		pen tablet display screen, or both as the active
		display.
Right Mouse		Tap this hotpad once to perform a right mouse
button		button click with your next pen tap.
Contrast Down		Tap these hotpads (or press and hold with the pen
Contrast Up		tip) to adjust the display screen contrast up or
		down.
Brightness		Tap this hotpad to change the display brightness
		setting. The brightness can be set to one of 2
		levels (high or low).

2-10 Using the Point 1600 Pen Tablet