Fujitsu 1600 manual Troubleshooting, System Will Not Resume or Turn On

Page 37

4.A dialog box is displayed after you tap the last of the cross-hair symbols. Choose one of the following in the dialog box:

•OK: If you are satisfied that you tapped the cross-hairs accurately. (Your taps are used to calibrate the screen.)

•Cancel: If you do not want to use your taps to calibrate the screen.

•Recalibrate: If you want to try again. The calibration instructions reappear. (Go to step 3 of this procedure.)

If you don’t choose any of the buttons in the dialog box within 20 seconds, your new calibration settings are discarded and previous calibration settings are used.

If you successfully performed the procedure above, the pen is now calibrated, and you can use the system as you normally would.

Troubleshooting

Solutions to some common problems are described in this section. If you are experiencing a problem with your Point 1600 pen tablet that you cannot solve by taking the actions described here, contact your local help desk.

System Will Not Resume or Turn On

If the system will not resume or turn on, check the following possible causes:

•The battery pack may be discharged to the critically low level or may be defective. When the battery pack cannot supply adequate power, the pen tablet will not resume or start. Connect an external power supply (such as the AC adapter or a cradle that supplies external power), or install a charged battery pack in the pen tablet.

•The pen tablet might be too hot. To avoid damage to heat-sensitive components, the pen tablet enters Suspend mode if it gets too hot. The system cannot resume operation until it cools off to a predetermined temperature. Move the pen tablet to a cooler location and prevent direct sunlight form shining on it.

Troubleshooting 3-5

Page 36 Page 38
Image 37
Page 36 Page 38
Contents Page Page UL Notices Agency ComplianceAddress Patrick Henry Drive Santa Clara, CA Telephone FCC NoticesTable of Contents Appendix a Agency Notices Getting Started Point 1600 Pen Tablet Features FrontPoint 1600 Pen Tablet Features Back Features and Controls Status LEDs MICLED Included with the Point 1600 Pen Tablet FMWDS3 Optional AccessoriesConnectivity Peripherals System Power States Using the Point 1600 Pen TabletUsing the Point 1600 Pen Tablet Low Battery Pack Conditions Low Battery Pack ConditionsPower On/Off Suspend/Resume Button ConfigurationNormal Resume OnlyStarting or Resuming the System Suspending the System Other Suspend/Resume Issues Shutting Down the System Using the PenPoint 1600 Pen and Tether To double-click an object quickly, or double-tap, onEnsuring Pen Accuracy Using HotpadsCharging the Battery Pack While Installed in the Pen Tablet Removing and Installing the Battery Pack Removing the Battery Pack Conserving Battery PowerPoint 1600 Pen Tablet Connectors Top Using Connectors and Peripheral InterfacesPoint 1600 Pen Tablet Connectors- Right PC Card Slot Modem Jack optionalUniversal Serial Bus USB Port IrDA PortUsing the Optional Built-In Modem Optional Wireless LAN AdapterSystem Interface Port Floppy Disk Drive PortUsing the Point 1600 Pen Tablet Installing a Screen Protector Care, Maintenance, and TroubleshootingProtecting the Display Screen Care, Maintenance, and Troubleshooting Protecting the Pen Tablet in Harsh Environments Taking Care of the PenAvoiding Overheating Storing the Pen TabletCalibrating the Pen System Will Not Resume or Turn On TroubleshootingDisplay Screen Is Blank or Difficult to Read System Will Not RespondInfrared Data Transfer Is Not Working Audio Volume Is Too Low Wireless LAN Connection Is LostCursor Is Not Tracking Pen Agency Notices 2Appendix DOC Industry Canada Compliance Notices Avis Aux Utilisateurs Du Réseau Téléphonique Canadien Avertissement 6Appendix Index-1 IndexIndex-2
Top Page Image Contents