IBM 715 P/N - 13H6715 manual Configuring Your Multimedia Modem Plus for WIN-OS/2

Configuring Your Multimedia Modem Plus for WIN-OS/2

IMPORTANT: If you are not running Windows or WIN-OS/2 applications from OS/2, you can skip to What-to-do-next at the end of this section.

Follow this procedure to verify the operating system settings for the WIN-OS/2 program.

1.To change your WIN-OS/2 System Settings:

a.Double-click on OS/2 SYSTEM on your OS/2 Desktop.

b.Double-click on SYSTEM SETUP.

c.Double-click on WIN-OS/2 SETUP.

d.Click on WIN-OS/2 SETTINGS in the WIN-OS/2 3.1 Session window.

e.In OS/2 Warp, a Category is displayed next. Select ALL DOS and WIN-OS/2 Settings and click on OK.

f.A window is displayed containing the following settings among others. Set the following variables them to the values shown:

i.WIN_RUN_MODE: 3.1 Enhanced Compatibility

ii.HW_TIMER: On

iii.INT_DURING_IO: On

g.Click on SAVE. Close all windows until you are back to the OS/2 system.

2.To change your WIN-OS/2 Command Prompt Settings:

a.Open the Command Prompts folder, click on WIN-OS/2 full screen using mouse button 2 (mouse button 2 is normally the right mouse button).

b.Click on Settings.

c.Select the Sessions Tab.

d.Select WIN-OS/2 Settings.

e.Select all DOS and WIN-OS/2 Settings and click on OK.

f.Select WIN_RUN_MODE.

g.A window is displayed containing a number of variables. Set the following variables them to the values shown:

WIN_RUN_MODE: 3.1 Enhanced Compatibility

HW_TIMER: On

INT_DURING_IO: On

h.Click on SAVE. Close Settings Notebook.

i.Repeat this procedure starting with 2.a. for the WIN-OS/2 Window icon.

3.If you have already completed the installation of the Multimedia Modem Plus under Windows close all open windows and go to “What to do next” at the end of this section.

4.If you are using OS/2 Warp with the self-contained Windows support, start a full screen WIN-OS/2 session.

5.Follow the procedure in "Installing the Software Under Windows 3.x or Windows 95." When you finish the installation procedure, return to 6. Do not run CONFIG.EXE. When the Mwave Windows diskettes have been installed, close the WIN-OS/2 session.

6.shutdown and then restart your computer.

7.Restart OS/2 and view the README.TXT by selecting the Read Me icon in the Multimedia Modem Plus program group. The README.TXT file contains important information about the Multimedia Modem Plus.

Page 18 of 47