L i f e B o o k N 6 4 0 0 S e r i e s U s e r ’ s G u i d e
The memory upgrade module is not something you should routinely remove from your notebook. Once it is installed, you should leave it in place unless you want to increase system memory capacity.
REMOVING A MEMORY UPGRADE MODULE
1.Perform steps 1 through 5 of Installing a Memory Upgrade Module.
2.Pull the clips sideways away from each side of the memory upgrade module at the same time.
3.While holding the clips out, remove the module from the slot by lifting it up and pulling towards the rear of your LifeBook notebook. (Figure
Figure 4-13. Removing a Memory Upgrade Module
4.Store the memory upgrade module in a static guarded sleeve.
5.Replace the cover by following steps 9 and 10 of Installing a Memory Upgrade Module.
After installing your added memory module, you must complete the Resetting the
Disk) Feature on page 31 for more information)
CHECKING THE MEMORY CAPACITY
Once you have changed the system memory capacity by replacing the installed module with a larger one, be sure to check that your notebook has recognized the change.
Check the memory capacity by clicking [Start]
The amount of memory displayed should be approxi- mately the total of all memory modules installed. There may be a discrepancy which is allocated for fixed video memory.
If the total memory displayed is incorrect, check that your memory upgrade module is properly installed. (If the module is properly installed and the capacity is still not correctly recognized, see Troubleshooting on page 53.
ENABLING/DISABLING TURBO MEMORY
Turbo Memory is an optional module that is used to act as a cache for
NVCache Partition: Please note that the NVCache partition on your hard disk drive is dedicated to the Turbo Memory module. If you see the NVCache partition, DO NOT copy any data to it or use this partition directly. Doing so could result in data loss or corruption, for which Fujitsu is not responsible.
Enabling Windows ReadyBoost™
To enable Windows ReadyBoost for Intel® Turbo Mem- ory, perform the following simple steps:
1.Click on Start
2.Locate the Intel Turbo Memory program group.
3.Select Intel Turbo Memory Console.
4.Select [Continue] when you see the Microsoft® Windows User Account Control prompt that says “A program needs your permission to continue. If you started this program, continue.”
5.Select [Enable Windows ReadyBoost].
6.Reboot your system.
46