Fujitsu C1410 manual Modular Bay Devices, Removing and Installing Modular Devices, Cold-swapping

clio.book Page 18 Friday, June 2, 2006 10:37 AM

L i f e B o o k C 1 4 0 0 S e r i e s N o t e b o o k - S e c t i o n T w o

Modular Bay

Modular Bay Release Latch

Figure 2-16 Modular Bay

Modular Bay Devices

Your Fujitsu LifeBook notebook contains a Modular Bay. The Modular Bay can house an optical drive, a Lithium ion battery, or a weight saver. (Figure 2-16)

Your Modular Bay will have one of the following devices installed.

■Modular Dual-Layer Multi-Format DVD Writer: This allows you to access movies, software, and audio DVD/CDs and record to DVD, CD, and DVD-RAM discs.

3.Pull out the Modular Bay release latch. This will push your device out slightly, allowing you to remove it.

4.Slide your device out until it is clear of the bay. This will require light force.

Modular Bay Release Latch

(a) (b)

■Modular DVD/CD-RW combo drive: This allows you to access movies, software, and audio DVD/CDs as well as to write to CDs.

■Modular DVD-ROM drive: This allows you to access software, data, video, or audio CDs and DVDs.

■Modular Lithium ion battery: This is a rechargeable battery that can be used to power your LifeBook note- book when an adapter is not connected.

(c) (d)

Figure 2-17 Removing/installing a device in the Modular Bay

■Weight Saver: This is used to fill the bay when no device is needed.

REMOVING AND INSTALLING

MODULAR DEVICES

There are two ways to remove and install modular devices in the Modular Bay:

■Cold-swapping: swapping devices while your LifeBook notebook is powered off.

■Hot-swapping: swapping devices while your system is active using the Unplug/Eject icon from your taskbar.

You should never leave your Modular Bay empty when the notebook is in operation. If left empty, dust or foreign matter may accumulate inside the notebook.

Cold-swapping

To cold-swap modular devices in your Modular Bay follow these easy steps: (Figure 2-17)

1.Close any open files.

2.Shut down your LifeBook notebook.

18

Be careful when aligning and seating devices in the bay. If the fit is incorrect, you may damage the bay or the device. If the device does not move easily in the bay, remove it, and check for dirt or foreign objects. It will require a firm push to latch the device in place.

5.Slide the device you are installing into your notebook until it clicks into place.

6.It is now safe to turn your notebook back on.

7.You can now access and use the device.

Your LifeBook notebook will automatically detect the new device and activate it within your system. The drive letters associated with the device will be created and listed under My Computer and Windows Explorer.

Hot-swapping

Under Windows XP, hot-swapping is provided through the Unplug or Eject Hardware utility.

The icon for the utility appears on the taskbar. Click on the icon and follow the on-screen instructions.