Fujitsu C1410 manual Serial Port, Docking Port, Universal Serial BUS Ports, Infrared Port

clio.book Page 45 Friday, June 2, 2006 10:37 AM

Figure 4-14. Connecting a Parallel Device

SERIAL PORT

The serial port, or COM port, located on the system and on the optional Port Replicator allows you to connect serial devices, such as printers or scanners. In order to connect a serial interface device follow these easy steps:

1.Align the connector with the port opening.

2.Push the connector into the port until it is seated.

3.Tighten the two hold-down screws, located on each end of the connector.

DOCKING PORT

The docking port is used for the connection of your notebook to an optional port replicator or docking station. In order to connect your notebook to one of these devices follow the instructions that came with your docking port. (See figure 2-7 on page 10 for location)

UNIVERSAL SERIAL BUS PORTS

There are four USB 2.0 ports on this system (three on the back and one on the side). The Universal Serial Bus

2.0ports (USB) allow you to connect USB devices such as external game pads, pointing devices, keyboards and/ or speakers.

In order to connect a USB device follow these steps:

1.Align the connector with the port opening.(Figure 4- 15)

2.Push the connector into the port until it is seated.

Due to the ongoing changes in USB tech- nology and standards, not all USB devices and/or drivers are guaranteed to work.

U s e r I n s t a l l a b l e F e a t u r e s

Figure 4-15. Connecting a USB Device

INFRARED PORT

The infrared IrDA (4Mbps) port allows for wireless data transfer between your notebook and other IrDA- compatible devices, such as another computer or a printer, without the use of a cable. (See figure 2-4 on page 7 for location)

It is important to keep in mind that while carrying out IR communication, both devices must be placed so their infrared ports are directly facing each other without obstruction. The devices must be separated by at least 6" but no more than 36" for maximum performance.

The following conditions may interfere with infrared communications:

■A television, radio remote control unit, or a wireless headphone is being used nearby.

■Direct sunlight, fluorescent light, or incandescent light shines directly on the port.

■Do not move either device while com- munication is active as it may interrupt data transmission.

■Be careful not to scratch the infrared port lens. Dirt, scratches, or other sur- face marks can degrade operation.

45