Fujitsu D1859 technical manual Mounting heat sink

Add-on modules / Upgrading

Mounting heat sink

i Use only the heat sink supplied with your system!

Be sure to use heat conducting material between the processor and the heat sink. If a heat conducting pad (rubber-like foil) is already applied to the heat sink, then use it. Otherwise you must apply a very thin layer of heat conducting paste.

Heat conducting pads can only be used once. If you remove the heat sink, you must clean it and apply new heat conducting paste before you remount it.

1

2

2

2

2

►Depending on the configuration variant, you must pull a protective foil off the heat sink or coat the heat sink with heat conducting paste before fitting it.

►Secure the heat sink - depending on the model - with four screws or push it into the mounts.

20 D1859 (Econel 50)